Abstract:Abstract Recent studies have benchmarked the prediction of wave vertical bending moment (VBM) of ship in waves [1][2], and found significant scatter among the numerical codes. Unfortunately, experimental data in extreme waves, that are relevant to ship design, are not often easily accessible, nor completely fitted to rigorous comparison to numerical codes. Then, the improvement of numerical tools and the modelling of ship’s internal loads still requires accurate experimental data measured in steep waves (ratio wave height H to wavelength λ, H/λ = 0.1) where the ship behavior and loads are modified by non-linearities. Thus, in order to validate simulation codes, which underlies rules requirement, and to establish criteria that makes ships safer to sail in severe sea conditions, experiments are carried out in the 50m × 30m × 5m hydrodynamic and ocean engineering tank of Ecole Centrale Nantes. A 1/65th scaled model of a 6750-TEU containership is used. The ship is moored and several combinations of wavelength and wave height are tested. While segmented hulls are commonly instrumented with strain gauges, the present experiments are performed on a segmented hull with a 6DOF sensor located close to the amidship. This setting allows for a very stiff model which dramatically reduces the hydroelastic effects. According to previous study [1], the position of the sensor is chosen where the bending moment is supposed to reach a maximum value. The model motion is measured through a Qualisys IR tracking system and accelerometers are located on the fore and aft of the beam. Also, each of the 9 segments is equipped with a 3DOF dynamometer to measure the hydrodynamic loads on the hull. This allows for recovering the hydrodynamic loads on the segments and then to compute the shear force and bending moment discretized all over the ship length. A comparison is therefore possible with the 6DOF sensor. Details of the computations are given in the paper. A particular attention is paid to the reproducibility and repeatability of the tests. The innovative experimental setup and the measured data are presented in the paper. Based on previous studies [3], the effects of the non-linearities are also discussed.

Springing Analysis of Elastic Vessels in Head and Oblique Seas Including Nonlinear Effects Due to Second Order Diffraction Pressures

Springing loads analysis of large‐scale container ships in regular waves

Experimental investigation of nonlinear springing and fatigue assessment of a 308,000 DWT oil tanker and a 205,000 DWT bulk carrier in a basin

Model Analysis of Green Water Phenomena and Loading for Ship Sailing with Slow Speed

Fatigue Failure Analysis and Simulation Calculation of Submarine Suspended Pipelines

Experimental Assessment of Vertical Shear Force and Bending Moment in Severe Sea Conditions

Enhanced Multi-Springs Model for Estimating Suction Caisson Responses under Cyclic Lateral Loading

CFD-FEM simulation of hydroelastic responses and slamming loads of a bow-flare ship advancing in head regular waves

Modelling Sea-Surface Wave Motion and Ship Response Using Smoothed Particle Hydrodynamics and Finite Element Analysis

Investigation of vessel slamming and fatigue using a full-scale test sequence

Investigation on Heave Motion and Load Response of a FPSO in Regular Waves by Fully Nonlinear Method

Nonlinear bending moments of an ultra large container ship in extreme waves based on a segmented model test

Numerical study of slamming and whipping loads in moderate and large regular waves for different forward speeds

Solving for hydroelastic ship response using a high-order finite difference method on overlapping grids at zero speed

Assessment of Ultimate Strength of a Typical Truss Spar Using Nonlinear Finite Element Analysis

Investigation of a weathervaning FPSO based on a fully nonlinear boundary element method

Time-domain analysis of nonlinear motion responses and structural loads on ships and offshore structures: development of WISH programs

Experimental Study on the Effect of Extreme Waves on a LNG Carrier

Analysis of the overall structural strength and optimization recommendations for ultra-large container ships based on the improved equivalent design wave method

A fully nonlinear BEM-beam coupled solver for fluid–structure interactions of flexible ships in waves

Experimental study on the fatigue damage of designed T-type specimen with high-low frequency superimposed loading