Abstract:Abstract Recent studies have benchmarked the prediction of wave vertical bending moment (VBM) of ship in waves [1][2], and found significant scatter among the numerical codes. Unfortunately, experimental data in extreme waves, that are relevant to ship design, are not often easily accessible, nor completely fitted to rigorous comparison to numerical codes. Then, the improvement of numerical tools and the modelling of ship’s internal loads still requires accurate experimental data measured in steep waves (ratio wave height H to wavelength λ, H/λ = 0.1) where the ship behavior and loads are modified by non-linearities. Thus, in order to validate simulation codes, which underlies rules requirement, and to establish criteria that makes ships safer to sail in severe sea conditions, experiments are carried out in the 50m × 30m × 5m hydrodynamic and ocean engineering tank of Ecole Centrale Nantes. A 1/65th scaled model of a 6750-TEU containership is used. The ship is moored and several combinations of wavelength and wave height are tested. While segmented hulls are commonly instrumented with strain gauges, the present experiments are performed on a segmented hull with a 6DOF sensor located close to the amidship. This setting allows for a very stiff model which dramatically reduces the hydroelastic effects. According to previous study [1], the position of the sensor is chosen where the bending moment is supposed to reach a maximum value. The model motion is measured through a Qualisys IR tracking system and accelerometers are located on the fore and aft of the beam. Also, each of the 9 segments is equipped with a 3DOF dynamometer to measure the hydrodynamic loads on the hull. This allows for recovering the hydrodynamic loads on the segments and then to compute the shear force and bending moment discretized all over the ship length. A comparison is therefore possible with the 6DOF sensor. Details of the computations are given in the paper. A particular attention is paid to the reproducibility and repeatability of the tests. The innovative experimental setup and the measured data are presented in the paper. Based on previous studies [3], the effects of the non-linearities are also discussed.

Nonlinear bending moments of an ultra large container ship in extreme waves based on a segmented model test

Springing Analysis of Elastic Vessels in Head and Oblique Seas Including Nonlinear Effects Due to Second Order Diffraction Pressures

Springing loads analysis of large‐scale container ships in regular waves

Model Analysis of Green Water Phenomena and Loading for Ship Sailing with Slow Speed

Study on the Resistance of a Large Pure Car Truck Carrier with Bulbous Bow and Transom Stern

Experimental Assessment of Vertical Shear Force and Bending Moment in Severe Sea Conditions

Hydroelasticity of a 21000TEU containership under freak waves by fluid-flexible structure interaction simulations

Analysis of the overall structural strength and optimization recommendations for ultra-large container ships based on the improved equivalent design wave method

Research on Structural Collapse of a Containership under Combined Bending–Torsion by Oblique Waves

Effects of design and fabrication of segmented ship models on test results of wave-induced loads

Experimental Study on the Effect of Extreme Waves on a LNG Carrier

Dominant conditions for strong resonance of an advancing containership under small-amplitude regular waves

A fully nonlinear BEM-beam coupled solver for fluid–structure interactions of flexible ships in waves

CFD-FEM simulation of hydroelastic responses and slamming loads of a bow-flare ship advancing in head regular waves

Numerical Convergence on the Hydroelasticity of a Large Containership

Numerical study of slamming and whipping loads in moderate and large regular waves for different forward speeds

A monitoring method of hull structural bending and torsional moment

Investigation on Heave Motion and Load Response of a FPSO in Regular Waves by Fully Nonlinear Method

Dynamic Analysis of the Structure of a Container Ship

Study of a Container Ship with Breaking Waves at High Froude Number Using URANS and DDES Methods

Numerical Simulation of Deck Waves of Container Vessel Based on Numerical Viscous Wave Tank