Abstract:Abstract Recent studies have benchmarked the prediction of wave vertical bending moment (VBM) of ship in waves [1][2], and found significant scatter among the numerical codes. Unfortunately, experimental data in extreme waves, that are relevant to ship design, are not often easily accessible, nor completely fitted to rigorous comparison to numerical codes. Then, the improvement of numerical tools and the modelling of ship’s internal loads still requires accurate experimental data measured in steep waves (ratio wave height H to wavelength λ, H/λ = 0.1) where the ship behavior and loads are modified by non-linearities. Thus, in order to validate simulation codes, which underlies rules requirement, and to establish criteria that makes ships safer to sail in severe sea conditions, experiments are carried out in the 50m × 30m × 5m hydrodynamic and ocean engineering tank of Ecole Centrale Nantes. A 1/65th scaled model of a 6750-TEU containership is used. The ship is moored and several combinations of wavelength and wave height are tested. While segmented hulls are commonly instrumented with strain gauges, the present experiments are performed on a segmented hull with a 6DOF sensor located close to the amidship. This setting allows for a very stiff model which dramatically reduces the hydroelastic effects. According to previous study [1], the position of the sensor is chosen where the bending moment is supposed to reach a maximum value. The model motion is measured through a Qualisys IR tracking system and accelerometers are located on the fore and aft of the beam. Also, each of the 9 segments is equipped with a 3DOF dynamometer to measure the hydrodynamic loads on the hull. This allows for recovering the hydrodynamic loads on the segments and then to compute the shear force and bending moment discretized all over the ship length. A comparison is therefore possible with the 6DOF sensor. Details of the computations are given in the paper. A particular attention is paid to the reproducibility and repeatability of the tests. The innovative experimental setup and the measured data are presented in the paper. Based on previous studies [3], the effects of the non-linearities are also discussed.

Investigation of vessel slamming and fatigue using a full-scale test sequence

Springing Analysis of Elastic Vessels in Head and Oblique Seas Including Nonlinear Effects Due to Second Order Diffraction Pressures

A Method for Fatigue Evaluation of Catamaran Wet Deck Considering Slamming Load

Experimental study of wet deck slamming for a SWATH in regular waves

Theoretical and Experimental Study on Nonlinear Hydroelastic Responses and Slamming Loads of Ship Advancing in Regular Waves

Evolution of slamming load and flow field in water-entry process of trimaran ship section

Fatigue Overview of Ship Structures under Induced Wave Loads

Experimental study of slamming pressure for a trimaran section with different drop heights and heel angles

Experimental Study on the Dynamical Response of Elastic Trimaran Model under Slamming Load

Experimental and Numerical Study of Slamming Problem for a Trimaran Hull

Slamming load on trimaran cross section with rigid and flexible arches

Experimental study on the drop test on wet deck slamming for a SWATH segment model

Experimental Assessment of Vertical Shear Force and Bending Moment in Severe Sea Conditions

Transient Response of the Bow Structure Under Slamming Loads

Investigation of trimaran slamming under different conditions

Numerical study of slamming and whipping loads in moderate and large regular waves for different forward speeds

Experimental study on the dynamic response of a 3-D wedge under asymmetric impact

Free-Drop Experimental and Simulation Study on the Ultimate Bearing Capacity of Stiffened Plates with Different Stiffnesses under Slamming Loads

Slamming of ships: where are we now?

Numerical simulation of ship motion and non-linear sea loads of a modern frigate in regular waves

Experimental and Numerical Analysis of Bow Slamming and Whipping in Different Sea States