Abstract:To investigate the safe, stable, and economically viable operation of a boiler under ultra-low-load conditions during the deep peaking process of coal-fired units, a numerical simulation study was conducted on a 660 MW front- and rear-wall hedge cyclone burner boiler. The current research on low load conditions is limited to achieving stable combustion by adjusting the operating parameters, and few effective boiler operating parameter predictions are given for very low-load conditions, i.e., below 20%. Various burner operation modes under ultra-low load conditions were analyzed using computational fluid dynamics (CFDs) methods; this operation was successfully tested with six types of pulverized coal combustion in this paper, and fitting models for outlet flue gas temperature and NOx emissions were derived based on the combustion characteristics of different types of pulverized coal. The results indicate that under 20% ultra-low-load conditions, the use of lower burners leads to a uniform temperature distribution within the furnace, achieving a minimum NOx emission of 112 ppm and a flue gas temperature of 743 K. Coal type 3, with the highest carbon content and a calorific value of 22,440 kJ/kg, has the highest average section temperature of 1435.76 K. In contrast, coal type 1 has a higher nitrogen content, with a maximum cross-sectional average NOx concentration of 865.90 ppm and an exit NOx emission concentration of 800 ppm. The overall lower NOx emissions of coal type 3 are primarily attributed to its reduced nitrogen content and increased oxygen content, which enhance pulverized coal combustion and suppress NOx formation. The fitting models accurately capture the influence of pulverized coal composition on outlet flue gas temperature and NOx emissions. This control strategy can be extended to the stable combustion of many kinds of coal. For validation, the fitting error bar for the predicted outlet flue gas temperature based on the elemental composition of coal type 6 was 8.09%, whereas the fitting error bar for the outlet NOx emissions was only 1.45%.

B215 NUMERICAL SIMULATIONS OF COMBUSTION OPTIMIZAITON FOR A 600 MW TENGENTIALLY COAL-FIRED SUPER-CRITICAL BOILER(Combustion-8)

Numerical Simulations Of Combustion Optimizaiton For A 600 Mw Tengentially Coal-Fired Super-Critical Boiler

Study on coal combustion characteristics in a 350MW supercritical tangentially boiler

Numerical investigation on oxy-combustion characteristics of a 200MW e tangentially fired boiler

Numerical Investigation on the Flow, Combustion, and NOX Emission Characteristics in a 660 MWe Tangential Firing Ultra-Supercritical Boiler

E305 NUMERICAL SIMULATIONS ON THE EFFECT OF OVER-FIRE AIR TO THE COMBUSTION PERFORMANCE IN A 2950 T/H TANGENTIAL-FIRED BOILER(Boiler-1)

Numerical Investigation of Combustion Optimization in a Tangential Firing Boiler Considering Steam Tube Overheating

Study on Combustion Characteristics and NOx Formation in 600 MW Coal-Fired Boiler Based on Numerical Simulation

Numerical simulation and optimization for combustion in a 600 MW unit swirl opposed boiler firing blended coals

Investigations on combustion optimization and NOX reduction of a 600-MWe down-fired boiler: Influence of rearrangement of tertiary air and jet angle of secondary air and separated over-fire air

Numerical Evaluation of Heat Transfer and NOx Emissions under Deep-Air-staging Conditions Within a 600 MWe Tangentially Fired Pulverized-Coal Boiler

Numerical Simulation of Multifuel Combustion in A 200 Mw Tangentially Fired Utility Boiler

Numerical Simulations On The Effect Of Over-Fire Air To The Combustion Performance In A 2950 T/H Tangential-Fired Boiler

Numerical Simulation Study on the Stable Combustion of a 660 MW Supercritical Unit Boiler at Ultra-Low Load

Numerical Investigation of Different Burner Arrangement on A Coal-Fired Boiler

Numerical Simulation of Combustion Processes in an Ultra Supercritical Boiler

Experiment and Numerical Simulation Investigations of the Combustion and NOx Emissions Characteristics of an Over-Fire Air System in a 600 MWe Boiler

Numerical Simulation of the NOx Emissions in a 1000 MW Tangentially Fired Pulverized-Coal Boiler: Influence of the Multi-group Arrangement of the Separated over Fire Air

Combined Operation Mode of Sub-Critical W-flame Boiler and Coal Mill Optimized Numerical Simulation

Numerical Study of Pulverized Coal Combustion and Optimization of Air Distrbution in a Boiler with 135 t/h

Numerical Optimization of Burner Deflection Angle at Half Load for a 660 MW Tangentially Fired Boiler