Tertiary Air Operation Optimization Aiming at Low NO_x Combustion in Boiler

Kefa Cen
2008-01-01
Abstract:Fluent software was used to simulate pulverized coal(PC) combustion in a 410 t/h boiler which had a PC bin and used hot air as PC carrier air and exhaust flow of mills as tertiary air.The tangential circle and the NOx concentration in furnace flow were obtained.Simulation showed that the high velocity tertiary air spray decreased the tangential circle diameter and increased the NOx concentration near the tertiary air ports level.During the boiler overhaul period,the tertiary air system was retrofitted and the coal reburning technology was applied to realize low NOx combustion.The tertiary air operation was optimized after the retrofit.Experimental results indicated that NOx emission was affected remarkably by the tertiary air operation mode and the NOx emission difference was 63.8% relatively and 148 mg/m3 absolutely.NOx emission increased as tertiary air flow increasing when both mills run.NOx emission was lest at no mill running,less at single mill running and highest at both mills running.And unburnt carbon(UBC) was highest at both mills running.The optimal operation condition was mill B running,on which NOx emission and UBC in fly ash can be kept in good range.
What problem does this paper attempt to address?