Abstract:The current research of hydrodynamic bearing in blood pump mainly focuses on the bearing structure design.Compared with the typical plane slider bearing and Rayleigh step bearing,spiral groove bearing has excellent performance in load-carrying capacity.However,the load-carrying capacity would decrease significantly with increasing flow rate in conventional designs.In this paper,the special treatment is made to the upper spiral groove bearing to make sure that both the circulatory flowing and load-carrying capacity are high.Three-dimensional computational fluid dynamics（CFD） models in the space between rotor and shaft are developed by using FLUENT software.Effects of groove number,film height and groove depth on load-carrying capacity of the spiral groove bearings are investigated by orthogonal experiment design.The experimental results show that film height is the most remarkable factor to the load-carrying capacity.The variation tendency of load-carrying capacity reveals that the best combination of geometry is the one with groove number of 8,film height 0.03 mm and groove depth 0.08 mm.The velocity and pressure distributions in spiral groove bearings are also analyzed,and the analysis result shows that the distributions are in conformity with the design of the blood pump based on the principle of hydrodynamic bearing.The displacement of the rotor with the best combination parameters is tested by using laser displacement sensors,the testing result shows that the suspending performance is satisfactory both in axial and radial directions.This research proposes a bearing design method which has sufficient load-carrying capacity to support rotor as an effective passive hydrodynamic bearing.

Numerical Simulation Investigation on Flow Field of Axial Blood Pump

Modelling and Experiment Study on Fluid Character of Axial Piston Pump

Study of CFD Simulation on Embedded Axial Blood Pump

Numerical Simulation and Comparative Analysis of Flow Field in Axial Blood Pumps

Applications of CFD Technique in the Design and Flow Analysis of Implantable Axial Flow Blood Pump

DESIGN OF IMPLANTABLE AXIAL-FLOW BLOOD PUMP AND NUMERICAL STUDIES ON ITS PERFORMANCE

Research of CFD Simulative Optimization on Impeller Structure of Axial Blood Pump

The Inside Flow Field Simulation of Pump-jet Propulsor Based on the Software FLUENT

Numerical Simulation on Internal Flow in the Screw Centrifugal Pulp Pump

Flow field CFD analysis of axial flow blood pump

Numerical Simulation and Experimental Validation of the Flow Field in Axial Flow Pump

Hemolysis and Flow Field in New Streamlined Axial Blood Pump

COMPARISON AND EXPERIMENTAL VALIDATION OF TURBULENCE MODELS FOR AN AXIAL FLOW BLOOD PUMP

Digital Simulation to the Development of Axial Blood Pump for Artificial Heart

Numerical Investigations on Flow Characteristics of Micro-Centrifugal Blood Pump

Numerical Simulation and Analysis on Hydraulic Performance in Vertical Canned Motor Pump

Comprehensive study on simulation, performance evaluation and optimization strategies for blood pumps

Numerical Simulation and Experimental Research on Passive Hydrodynamic Bearing in a Blood Pump

Numerical Simulation of Hemolysis in a Micro Axial Flow Blood Pump

Research on fluid properties of the anxial flow blood pump based on CFD

Numerical Simulation and Experimental Study on Flow Field in an Axial Flow Pump