Abstract:A novel tunnel growth model is proposed to reveal how hydrogen is transported out of tunnels and explain the phenomena during etching process of aluminum foil for capacitor. Experimental results indicated that tunnel density increased and tunnel width decreased with temperature increasing at the temperature range of 70–80°C. The pressure in electrolyte had an effect on the tunnel density. The tunnel density after etching at 0.2atm was larger than that at 1atm. A pulse electrochemical etching process is described according to the novel tunnel growth model. It considers that hydrogen bubble of nanometer dimension is absorbed on the tunnel’s walls surface during the pulse electrochemical etching process, and the saturated hydrogen at the end of the tunnel is accumulated to be a large bubble before hydrogen is transported out of the tunnel. The large bubble will emanate from the end of tunnel when the pressure in the bubble is equal to that outside. The wall surface passivation phenomena is explained by this model; the naturally corrugated texture with ripples of about 0.1μm in tunnel’s walls surface is regarded to be produced by the potential periodical changes, which are caused by the large hydrogen bubble at the end of the tunnel. At the same time, the effect of temperature and pressure on the morphology of the tunnel is also investigated by use of the model. The pressure of the large hydrogen bubble in the tunnel is calculated according to the date in other references when the period of the pulse electrochemical etching is inferred to be 3ms at their experimental conditions. The proposed process of pulse electrochemical etching could explain well the calculation results and the SEM images of etched tunnels under the same experimental conditions.

The Influence of H2SO4/HCl Ratio and Al3+ Content on the Tunnel Growth of High Purity Aluminum Foil

Growth Control of Transverse Tunnels for Al Foil in Electrolytic Capacitor

Effects of the solution flow rate on the growth of aluminum etch tunnels

Effects of Current Density on the Growth of Aluminum Etch Tunnels

Effect of Etch Conditions on Expanding Surface Corrosion of Anodic Foil for Aluminum Electrolytic Capacitors

Research Progress of Tunnel Growth in Aluminum Foil for Capacitor

Second Growth Law of Tunnel Hole in Etched Aluminum Foil for Electrolytic Capacitor

Tunnel Growth Mechanism of Aluminum Foils During Etching on Corrosion Cell

Influence of annealing on pitting uniformity of aluminum foil for high voltage electrolytic capacitor

Influences of trace metal ions in electrolyte on the etching characteristics of high purity aluminum foil under DC current

Studies and Applications of Phosphoric Acid Treatment on Low Voltage Formed Aluminum Foils

Effects of Content and Distribution of Trace Element on Texture and Property of High-Voltage Electronic Aluminum Foil

Study on technology and mechanism of DC impulse current etching of aluminum foil for middle and high voltage electrolytic capacitor

Electrochemical etching model in aluminum foil for capacitor

Influence of Trace Mg on Corrosion Structure of High Voltage Aluminum Foil

Progress in the Studies of Anode Foils for High Voltage Electrolytic Capacitor

Increasing Cube Texture in High Purity Aluminium Foils for Capacitors

Influence of Oxide Film Surface Appearance on Capacitor Load Life

Study on Aluminum Foils for Aluminum Electrolytic Capacitor

Effect of Pretreatment on the Pitting Corrosion of the Anode Foils for the Aluminum Electrolytic Capacitor

Effect of Annealing Method on Microelements Distribution and Corrosion Performance of Aluminum Foil for Low Voltage Electrolytic Capacitor