Abstract:The solid dissolution of Fe atoms into Cu matrix induced by mechanical alloying and subsequent thermal decomposition of Fe atoms from the solid solution in composition of Fe60Cu40 have been studied by X-ray diffraction (XRD), Mossbauer spectroscopy and the extended X-ray absorption fine structure (EXAFS) technique. The disappearance of elemental Fe and Cu XRD peaks and the presence of FCC structural XRD peaks illustrate the formation of FCC-Fe60Cu40 solid solution. Meanwhile, the new sextet spectrum with a broadening hyperfine magnetic field distribution also demonstrates that the alloying is on an atomic level and there exist complex coordination environments in the solid solution. EXAFS results Further prove the reality of atomic alloying from the clear observation of Fe atoms taking on FCC coordination in the solid solution. Additionally, a large reduction in the first shell coordination number for a center iron atom but not for a center Cu atom indicates the composition non-uniformity, which suggests that Fe atoms enrich the surface while Cu atoms enrich the core of a FCC nanocrystal. The variation of Mossbauer spectra against the annealing temperatures during thermal decomposition indicates that the Fe atoms at the surface readily nucleate and cluster into alpha -Fe at a temperature slightly below 250 degreesC, whereas the Fe atoms in the core of nano-sized crystals first cluster into gamma -Fe cohering to the FCC matrix at a temperature about 350 degreesC and then transform to alpha -Fe for further annealing at a higher temperature or for a longer time. (C) 2001 Elsevier Science B.V. All rights reserved.

Atomistic Mechanism of Nano-Scale Phase Separation in Fcc-Based High Entropy Alloys

Nanoscale phase separation in a fcc-based CoCrCuFeNiAl 0.5 high-entropy alloy

Multi-component Phase-Field Simulation of Microstructural Evolution and Elemental Distribution in Fe–Cu–Mn–Ni–Al Alloy

The Effect of Phase Separation on the Mechanical Behavior of the Co–Cr–Cu–Fe–Ni High-Entropy Alloy

Phase Volume Fraction-Dependent Strengthening in a Nano-Laminated Dual-Phase High-Entropy Alloy

Effect of Al addition on the microstructures and deformation behaviors of non-equiatomic FeMnCoCr metastable high entropy alloys

Phase transformation and strengthening mechanisms of nanostructured high-entropy alloys

Microstructure and Mechanical Properties of Face‐Centered‐Cubic‐Based Cr‐Free Equiatomic High‐Entropy Alloys

Early stage phase separation of AlCoCr0.75Cu0.5FeNi high-entropy powder at the nanoscale

Microstructure and Magnetic Properties of the FeCoNi(CuAl)0.8Ga0.06 High-Entropy Alloy During the Phase Transition

Understanding the physical metallurgy of the CoCrFeMnNi high-entropy alloy: an atomistic simulation study

Simultaneously enhancing the tensile strength and ductility of high entropy alloys by nanoscale precipitates/fillers

Unconventional Deformation Behaviours of Nanoscaled High-Entropy Alloys.

Microstructure of and mechanical properties of an as-cast fine-grain dual-phase Fe-based high entropy alloy formed via solid-state phase transformation

Phase decomposition and strengthening in HfNbTaTiZr high entropy alloy from first-principles calculations

Morphology, Structure and Composition of Precipitates in Al0.3CoCrCu0.5FeNi High-Entropy Alloy

Mechanical Alloying, Fine Structure and Thermal Decomposition of Nanocrystalline Fcc-Fe60cu40

Stability Prediction of AlCoCrFeMo 0.05 N 2 High Entropy Alloy by Kinetic Monte Carlo Method

Microstructure and mechanical properties of non equiatomic FeCoNiCuMo high entropy systems

Influence of multiwall carbon nanotube functionality and loading on mechanical properties of PMMA/MWCNT bone cements

Interplay between single phase solid solution strengthening and multi-phase strengthening in the same high entropy alloy