Abstract:Liquid crystal display (LCD) has been widely used in various electronic products. Chip-on-glass (COG)/anisotropic conductive film (ACF) interconnect technique is usually used to fabricate the LCD panels with high resolution and high quality. However, COG/ACF interconnect still has weakness that could cause severe reliability issues, e.g., no display. No display problem is considered to be caused by the increment of contact resistance of COG/ACF joints because of IC warpage, interface delamination and misalignment. In this study, a 3D global finite element (FE) model of whole LCD module was developed by implementing novel equivalent block method for the whole COG bonding process. The simulation results showed that IC warpage can be reduced by decreasing the temperature difference between bonding head and glass substrate, using low stress ACF as well as optimizing IC geometry. The global and local modeling indicated that von Mises stress of gold bump in the center region is much smaller than in the side region. The interface between ACF epoxy and glass would delaminate first and further cause the display failure. A slice of LCD module was modeled to investigate the misalignment solution with nonlinear elastic-plastic and sequential thermal-mechanical analysis. Numerical studies showed appropriate ACF with the properties of small elastic modulus, large coefficient of thermal expansion (CTE) and low glass transition temperature (T-g) could reduce misalignment effectively. Finally, electrical conductive characteristics of cracked conductive particle were revealed using a novel 3D FE model with cohesive element to further understand the conduction mechanism of ACF particles.

A Study of Flip-Chip Direct Attachment LED COBs with Metal Core Print Circuit Boards

Study On Solder Bonding Technology And Its Failure Mechanism

Design of Optical Structure for Chip-on-board Wafer Level Packaging LEDs

Chip-on-board (COB) wafer level packaging of LEDs using silicon substrates and chemical foaming process(CFP)-made glass-bubble caps

Reliability Evaluation for Solder Interconnect of Flip-chip LED

Impact Properties of Flip Chip Interconnection Using Anisotropically Conductive Film on the Glass and Flexible Substrate

Full-Color Led Display Research Based On Chip On Board(Cob) Package

A Design and Qualification of LED Flip Chip-on-Board Module with Tunable Color Temperatures

Thermodynamic simulation and analysis of metal bumps in flip-chip micro-LED packaging

A sandwich structure of multi-chip COB LED with double flat glass boards coated with phosphors film by screen printing technique

A Novel Cob Structure with Integrated Multifunction

Study of several key reliability problems of COG/ACF interconnect in LCD module

Study of the Thermomechanical Coupling Effect in COB Packaging Structures

Failure Analysis Of Die-Bonding Interfaces Between Led Chip And Heat Sink

Reliability Evaluation of Board-Level Flip-Chip Package under Coupled Mechanical Compression and Thermal Cycling Test Conditions

An Effective Way to Solve the Void Problem of Traditional Underfill Based on NCP Technology

Application of Nano Silver Sintering Technique on the Chip Bonding for Flip-Chip and Vertical Light Emitting Diodes

Effects of Voids on Mechanical and Thermal Properties of the Die Attach Solder Layer Used in High-Power LED Chip-Scale Packages

Finite Element Analysis of Wire Bonding Non-Stick Issue in Miniaturized Package Development

Improvement in optical performance and color uniformity by optimizing the remote phosphor caps geometry for chip-on-board light emitting diodes

High-Power Flip-Chip Monolithically integrated Light-Emitting diodes: Based on Self-Isolation Technology