Abstract:<p>Acoustic emission (AE) event location plays an important role in structural safety assessments. However, accurately locating an AE event is usually difficult, especially for a small structure. Interestingly, a pencil-lead break (PLB) experiment shows that the P-wave arrival time of a sensor is always significantly different (~260 µs) from that of the other sensors. This time difference is much greater than the P-wave travel time in the range of the experimental sample. Therefore, it can be inferred that there is a P-wave arrival time system error (PATSE) for each sensor. The PATSE may be due to a combined result of the sensor site effect and signal transfer delay time from the sensor to the signal storage. To handle this, a Bayesian inversion framework was built to estimate PATSEs. A synthetic test demonstrated the effectiveness of the proposed Bayesian method for noisy P-wave arrival time data. Then, Bayesian inversion was applied to 15 PLB events, which confirmed the existence of PATSE in an AE experiment for the first time. The average PATSE reached 1.47 µs without considering the P-wave arrival time significantly different sensor. The average location error of 25 PLB events was 14.30 mm and 6.58 mm for PATSE unremoved and removed data, respectively. To achieve this, a high-precision virtual field optimization location method (VFOM) was used. This demonstrates the necessity of removing the PATSEs. Finally, the AE event location performance for the PATSE unremoved and removed data was compared, where the AE events were obtained from the uniaxial compression of a red sandstone sample. The results indicated that there was a higher location detection success rate for the corrected data. The AE locations based on the corrected data were in a better correlation with the rock sample failure mode than that without correction. Moreover, increase the signal sampling frequency for AE event identification, use a real-time inverted 3D velocity model and update the PATSEs in real time could be used to further improve the AE event location accuracy.</p>

Source Location Techniques In Plate-Like Structures Based On Fiber Coupler Sensors

Coherent OTDR Based Ultra-High Sensitive Acoustic Sensor Assisted with Distributed Microstructured Optical Fiber(DMOF) and Hollow Cylinder Transducer

A Generalized Linear-location Method of Acoustic Emission Source

Passive Localization Based on Spectral Estimation Methods Using Sources of Opportunity

Acoustic emission source location from P-wave arrival time corrected data and virtual field optimization method

Improved Method for Acoustic Emission Source Location Based on DFB Laser Sensor and Particle Swarm Optimization Algorithm

Acoustic Emission Localization on a Large Anisotropic Composite Plate

Experimental and Numerical Investigation of Acoustic Emission Source Localization Using an Enhanced Guided Wave Phased Array Method

All-phase fast Fourier transform and multiple cross-correlation analysis based on Geiger iteration for acoustic emission sources localization in complex metallic structures

Acoustic Source Localization System Based on Channel-Merged Fiber Optics Acoustic Sensing Array

Acoustic source localization in composite plates using Sideband Peak Count – Index technique

Multiple Methods for Acoustic Emission Source Location in Metal Waveguides

A triangular acoustic emission source location method considering its anisotropic propagation behavior on the surface of finger-joint-laminated board

Impact of Model Knowledge on Acoustic Emission Source Localization Accuracy

Sensor Array Position in Acoustic Emission Monitoring of Mining

An adaptive localization method of simultaneous two acoustic emission sources based on energy filtering algorithm for coupled array signal

Locating acoustic emission sources in pseudo-triaxial experiments with the shortest path and orthogonal constraint

Three-dimensional sound source localization system based on fiber optic sensor array with an adaptive algorithm

Acoustic Source Localization in CFRP Composite Plate Based on Wave Velocity-Direction Function Fitting

Localization of Fiber Cable with Distributed Acoustic Sensing

Long-distance and continuous horizontal displacement sensor of deep excavation based on distributed optical fiber sensing