Abstract:<p>Acoustic emission (AE) event location plays an important role in structural safety assessments. However, accurately locating an AE event is usually difficult, especially for a small structure. Interestingly, a pencil-lead break (PLB) experiment shows that the P-wave arrival time of a sensor is always significantly different (~260 µs) from that of the other sensors. This time difference is much greater than the P-wave travel time in the range of the experimental sample. Therefore, it can be inferred that there is a P-wave arrival time system error (PATSE) for each sensor. The PATSE may be due to a combined result of the sensor site effect and signal transfer delay time from the sensor to the signal storage. To handle this, a Bayesian inversion framework was built to estimate PATSEs. A synthetic test demonstrated the effectiveness of the proposed Bayesian method for noisy P-wave arrival time data. Then, Bayesian inversion was applied to 15 PLB events, which confirmed the existence of PATSE in an AE experiment for the first time. The average PATSE reached 1.47 µs without considering the P-wave arrival time significantly different sensor. The average location error of 25 PLB events was 14.30 mm and 6.58 mm for PATSE unremoved and removed data, respectively. To achieve this, a high-precision virtual field optimization location method (VFOM) was used. This demonstrates the necessity of removing the PATSEs. Finally, the AE event location performance for the PATSE unremoved and removed data was compared, where the AE events were obtained from the uniaxial compression of a red sandstone sample. The results indicated that there was a higher location detection success rate for the corrected data. The AE locations based on the corrected data were in a better correlation with the rock sample failure mode than that without correction. Moreover, increase the signal sampling frequency for AE event identification, use a real-time inverted 3D velocity model and update the PATSEs in real time could be used to further improve the AE event location accuracy.</p>

Locating acoustic emission sources in pseudo-triaxial experiments with the shortest path and orthogonal constraint

Three-dimensional Acoustic Localization Algorithm Based on Coordinate Conversion

Efficient Localization of Low-Frequency Sound Source with Non-Synchronous Measurement at Coprime Positions by Alternating Direction Method of Multipliers.

A Bayesian Framework of Non-Synchronous Measurements at Coprime Positions for Sound Source Localization with High Resolution

A triangular acoustic emission source location method considering its anisotropic propagation behavior on the surface of finger-joint-laminated board

Multiple Methods for Acoustic Emission Source Location in Metal Waveguides

Acoustic emission localization in beams based on time reversed dispersion

A Gradient Vector Descent Strategy for Localizing Acoustic Emission Sources in Discontinuous Structures with a Hole

Cooperative acoustic emission locating with velocity tomography in true triaxial experiment

An Underwater Source Localization Method Using Bearing Measurements

3-D Near-Field Source Localization Using a Spatially Spread Acoustic Vector Sensor

Quasi-plane Shear Wave Propagation Induced by Acoustic Radiation Force with a Focal Line Region: a Simulation Study

Experimental and Numerical Investigation of Acoustic Emission Source Localization Using an Enhanced Guided Wave Phased Array Method

Acoustic emission source location from P-wave arrival time corrected data and virtual field optimization method

3-D Source Localization based on 1-D AOA Measurements: Low-Complexity and Effective Estimator

Acoustic emission positioning with multi-scale and multi-sensor constraints

Moving Sound Source Localization Based on Triangulation Method

Estimating DOA of near sound sources in the air using a single three-component geophone

Acoustic Emission Localization on a Large Anisotropic Composite Plate

On the Accuracy of Passive Source Localization Using Acoustic Sensor Array Networks

Improved Method for Acoustic Emission Source Location Based on DFB Laser Sensor and Particle Swarm Optimization Algorithm