Abstract:<p>Acoustic emission (AE) event location plays an important role in structural safety assessments. However, accurately locating an AE event is usually difficult, especially for a small structure. Interestingly, a pencil-lead break (PLB) experiment shows that the P-wave arrival time of a sensor is always significantly different (~260 µs) from that of the other sensors. This time difference is much greater than the P-wave travel time in the range of the experimental sample. Therefore, it can be inferred that there is a P-wave arrival time system error (PATSE) for each sensor. The PATSE may be due to a combined result of the sensor site effect and signal transfer delay time from the sensor to the signal storage. To handle this, a Bayesian inversion framework was built to estimate PATSEs. A synthetic test demonstrated the effectiveness of the proposed Bayesian method for noisy P-wave arrival time data. Then, Bayesian inversion was applied to 15 PLB events, which confirmed the existence of PATSE in an AE experiment for the first time. The average PATSE reached 1.47 µs without considering the P-wave arrival time significantly different sensor. The average location error of 25 PLB events was 14.30 mm and 6.58 mm for PATSE unremoved and removed data, respectively. To achieve this, a high-precision virtual field optimization location method (VFOM) was used. This demonstrates the necessity of removing the PATSEs. Finally, the AE event location performance for the PATSE unremoved and removed data was compared, where the AE events were obtained from the uniaxial compression of a red sandstone sample. The results indicated that there was a higher location detection success rate for the corrected data. The AE locations based on the corrected data were in a better correlation with the rock sample failure mode than that without correction. Moreover, increase the signal sampling frequency for AE event identification, use a real-time inverted 3D velocity model and update the PATSEs in real time could be used to further improve the AE event location accuracy.</p>

Improved Method for Acoustic Emission Source Location Based on DFB Laser Sensor and Particle Swarm Optimization Algorithm

In situ monitoring of FDM machine condition via acoustic emission

Reference-free Crack Detection and Localization by Nonlinear Laser Ultrasonic.

A triangular acoustic emission source location method considering its anisotropic propagation behavior on the surface of finger-joint-laminated board

Source Location Techniques In Plate-Like Structures Based On Fiber Coupler Sensors

Experimental and Numerical Investigation of Acoustic Emission Source Localization Using an Enhanced Guided Wave Phased Array Method

All-phase fast Fourier transform and multiple cross-correlation analysis based on Geiger iteration for acoustic emission sources localization in complex metallic structures

Determine the location of acoustic emission source on wood surface by using a wavelet-energy attenuation method

Development of an Artificial Neural Network for Source Localization Using a Fiber Optic Acoustic Emission Sensor Array

Linear Damage Location Using Fiber Optic Acoustic Emission Sensors for Structure Health Monitoring

Source Location Using an Optimized Microfiber Coupler Sensor Based on Modal Acoustic Emission Method

Acoustic emission source location from P-wave arrival time corrected data and virtual field optimization method

Acoustic emission localization in beams based on time reversed dispersion

Minimum Squared Error Method Based on Modal Analysis for Acoustic Emission Source Location Using Microfiber Coupler Sensor

A method based on virtual wave front for acoustic emission source location in laminates

Laser Self-Mixing Interference: Optical Fiber Coil Sensors for Acoustic Emission Detection

Acoustic Emission Localization on a Large Anisotropic Composite Plate

Impact Source Identification in a Carbon Fiber Reinforced Polymer Plate by Using Embedded Fiber Optic Acoustic Emission Sensors

Impact of Model Knowledge on Acoustic Emission Source Localization Accuracy

Particle Swarm Optimization Algorithm for Guided Waves Based Damage Localization Using Fiber Bragg Grating Sensors in Remote Configuration

Fiber Optic Acoustic Emission Sensor and Its Applications in the Structural Health Monitoring of CFRP Materials