Abstract:<p>Acoustic emission (AE) event location plays an important role in structural safety assessments. However, accurately locating an AE event is usually difficult, especially for a small structure. Interestingly, a pencil-lead break (PLB) experiment shows that the P-wave arrival time of a sensor is always significantly different (~260 µs) from that of the other sensors. This time difference is much greater than the P-wave travel time in the range of the experimental sample. Therefore, it can be inferred that there is a P-wave arrival time system error (PATSE) for each sensor. The PATSE may be due to a combined result of the sensor site effect and signal transfer delay time from the sensor to the signal storage. To handle this, a Bayesian inversion framework was built to estimate PATSEs. A synthetic test demonstrated the effectiveness of the proposed Bayesian method for noisy P-wave arrival time data. Then, Bayesian inversion was applied to 15 PLB events, which confirmed the existence of PATSE in an AE experiment for the first time. The average PATSE reached 1.47 µs without considering the P-wave arrival time significantly different sensor. The average location error of 25 PLB events was 14.30 mm and 6.58 mm for PATSE unremoved and removed data, respectively. To achieve this, a high-precision virtual field optimization location method (VFOM) was used. This demonstrates the necessity of removing the PATSEs. Finally, the AE event location performance for the PATSE unremoved and removed data was compared, where the AE events were obtained from the uniaxial compression of a red sandstone sample. The results indicated that there was a higher location detection success rate for the corrected data. The AE locations based on the corrected data were in a better correlation with the rock sample failure mode than that without correction. Moreover, increase the signal sampling frequency for AE event identification, use a real-time inverted 3D velocity model and update the PATSEs in real time could be used to further improve the AE event location accuracy.</p>

Sensor Array Position in Acoustic Emission Monitoring of Mining

Strategic Deployment in the Deep: Principled Underwater Sensor Placement Optimization with Three-Dimensional Acoustic Map.

A Generalized Linear-location Method of Acoustic Emission Source

Sonar Detection Performance Analysis with Environmental Uncertainty Using Vertical Array Data

A Secure and Accurate Localization Algorithm for Mobile Nodes in Underwater Acoustic Network

Acoustic emission positioning with multi-scale and multi-sensor constraints

Optimization and Numerical Verification of Microseismic Monitoring Sensor Network in Underground Mining: A Case Study

Multiple Methods for Acoustic Emission Source Location in Metal Waveguides

On Effective Placement of Acoustic Emission Sensor in Steel Framed Structure for Damage Detection

Bayesian optimal sensor placement for acoustic emission source localization with clusters of sensors in isotropic plates

Experimental and Numerical Investigation of Acoustic Emission Source Localization Using an Enhanced Guided Wave Phased Array Method

Acoustic emission source location from P-wave arrival time corrected data and virtual field optimization method

Prefabricated acoustic emission array system for landslide monitoring

A novel acoustic emission sensor design and modeling method for monitoring the status of high-speed train bearings

Impact of Model Knowledge on Acoustic Emission Source Localization Accuracy

Experimental investigation and field application of acoustic emission array for landslide monitoring

The Research of Acoustic Emission Signal Classification

Improved Location Algorithm of Coal Mine Monitoring System Based on Wireless Sensor Network

Research on Bearing Fault Monitoring Technology Based on the Acoustic Array in Working Environment

On the Accuracy of Passive Source Localization Using Acoustic Sensor Array Networks

Ultrasonic Array-Based Multi-Source Fusion Indoor Positioning Technology