Abstract:Multi-gigahertz fundamental repetition rate, tunable repetition rate and wavelength, ultrafast fiber lasers at wavelengths of 1.0, 1.5, and 2.0 µm are experimentally demonstrated and summarized. At the wavelength of 1.0 µm, the laser wavelength is tuned in the range of 1040.1-1042.9 nm and the repetition rate is shifted by 226 kHz in a 3-cm-long all-fiber laser by controlling the temperature of the resonator. Compared with a previous work where the maximum average power was 0.8 mW, the power in this study is significantly improved to 57 mW under a launched pump power of 213 mW, thus achieving an optical-to-optical efficiency of 27%. For comparison, a similar temperature-tuning technique is implemented in a Tm3+-doped ultrafast oscillator but, as expected, it results in a broader tunable range of 14.1 nm (1974.1-1988.2 nm) in wavelength as compared with the value of 1.8 nm for the wavelength of 1.0 µm. The repetition rate in the process is shifted by 294 kHz. For the high-frequency range from 100 kHz to 10 MHz, the value of integrated timing jitter gradually increases with an increase in temperature. Finally, to the best of our knowledge, for the first time, a new method for tuning wavelength and repetition rate is proposed and demonstrated for a femtosecond fiber laser at the wavelength of 1.5 µm. Through fine rotation of the alignment angle between the Er/Yb:glass fiber and a semiconductor saturable absorption mirror, the peak wavelength can be tuned in the range of 1591.4-1586.1 nm and the repetition rate is shifted by 60 kHz.

3-Ghz, Ultrafast Yb-fiber Laser Sources: Closing the Spectral Gaps

3 GHz, Yb-fiber laser-based, few-cycle ultrafast source at the Ti:sapphire laser wavelength

3 GHz few-cycle ultrafast source at 850nm

66 fs, 3 W all fiber Yb3+-doped mode-locked fiber laser

3 Ghz, Femtosecond Raman Soliton Source

3 GHz, Fundamentally Mode-Locked, Femtosecond Yb-fiber Laser.

Femtosecond Mode-locked Fiber Laser at 1 Μm Via Optical Microfiber Dispersion Management

Self-phase modulation enabled, wavelength-tunable ultrafast fiber laser sources: an energy scalable approach.

97-Watt, 1.08-Gigahertz Repetition Rate, Femtosecond Yb:fiber Laser Source

Old Wavelength, New Performance: Hectowatt 200-μJ-level Femtosecond fiber CPA System at 1064 Nm

High-energetic ultrafast fiber laser sources tunable from 920 to 1030 nm based on tapered photonic crystal fibers

All-Fiber High-Power 3 GHz Ultrafast Laser System At 2.0 μm

Femtosecond Yb-doped Tapered Fiber Pulse Amplifiers with Peak Power of over Hundred Megawatts

High-power broadband laser source tunable from 3.0 um to 4.4 um based on a femtosecond Yb:fiber oscillator

Fiber-Based High-Energy Femtosecond Pulses Tunable from 920 to 1030 Nm for Two-Photon Microscopy

2 Mu M Femtosecond Fiber Laser Source And Its Application For Mid-Ir Supercontinuum Generation

High-repetition-rate Ultrafast Fiber Lasers.

Femtosecond Red and Near-Infrared Lasers Due to Cascaded-Raman-Assisted Four-Wave Mixing in a Nonlinear Yb-Doped Fiber Amplifier

Low noise, self-phase-modulation-enabled femtosecond fiber sources tunable in 740-1236 nm for wide two-photon fluorescence microscopy applications

High-Power GHz Burst-Mode All-Fiber Laser System with Sub 300 fs Pulse Duration

An efficient high-power femtosecond laser based on periodic-layered-Kerr media nonlinear compression and a Yb:YAG regenerative amplifier