Abstract:Solid oxide fuel cells (SOFCs) can directly convert the chemical energy in fuels and oxidants into electrical energy because of their high operating temperatures, making them efficient and environmentally friendly. The high-temperature operating characteristic gives SOFCs numerous advantages, including flexible fuel capability and high efficiency. However, it leads to a non-uniform temperature distribution that results in the performance degradation of SOFCs or even system failure. Owing to the high-temperature and gas-sealed operating environment, measuring the temperature distribution in SOFC stacks using experimental methods is extremely difficult. In this study, an SOFC internal temperature measurement device is developed and constructed to investigate the impacts of various factors, including the operating current density and gas flow rate, on the electrical output performance and temperature distribution within an SOFC stack. The experimental results indicate that the SOFC temperature gradually increases with increasing current density. Furthermore, the temperature difference between the spatial locations increases, and the inhomogeneity of the temperature distribution becomes more significant. During the growth of the current density i from 0.1 A/cm 2 to 0.5 A/cm 2 , the maximum temperature gradient on the SOFC electrodes reaches the lowest level at i = 0.3 A/cm 2 . The maximum current density and power density increase as the gas flow rate increases. However, the electrical efficiency and fuel utilization ratio gradually decrease, and the uniformity of the temperature distribution deteriorates. Air flux is the main factor that dominates the temperature distribution in SOFCs. The temperature on the cathode side is higher than that on the anode side. These results contribute to understanding the temperature distribution patterns in SOFCs and provide some guiding significance for SOFC design and operation optimization.

Interdigitated Heat/Mass Transfer and Chemical/Electrochemical Reactions in a Planar Type Solid Oxide Fuel Cell

Numerical Modeling and Current Collection Designs for Flat-Chip Solid Oxide Fuel Cell

Numerical Investigation of Heat/Flow Transfer and Thermal Stress in an Anode-Supported Planar SOFC

Effect of the Reactant Transportation on Performance of a Planar Solid Oxide Fuel Cell

Numerical research on carbon activity, fuel utilization, chemical reaction, and temperature distribution for IT single planar SOFC

Numerical Analysis of Thermal Stress for a Stack of Planar Solid Oxide Fuel Cells

Momentum-species-heat-electrochemistry distribution characteristics within solid oxide fuel cell stack with complex inter-digital fuel channels

Numerical Analysis of the Internal Fuel Processing in Solid Oxide Fuel Cells

Optimization of interconnect flow channels width in a planar solid oxide fuel cell

Numerical Simulation of Cell-to-cell Performance Variation Within a Syngas-Fuelled Planar Solid Oxide Fuel Cell Stack

Three-dimensional numerical investigation on the effect of interconnect design on the performance of internal reforming planar solid oxide fuel cell

Simulation and Analysis of Thermal Stress and Sintering Warpage of Planar Solid Oxide Fuel Cells

Numerical Simulation of Multi-Channel Planar Solid Oxide Fuel Cell Unit by Integrating Continuum Micro-Scale Pen Sub-Model

Thermo-Electro-Chemo-Mechanical Coupled Modeling of Solid Oxide Fuel Cell with LSCF-GDC Composite Cathode

Effect of Electrolyte Thickness on Electrochemical Reactions and Thermo-Fluidic Characteristics inside a SOFC Unit Cell

Experimental investigation of temperature distribution in solid oxide fuel cells

Structure optimization and thermal field analysis of biogas derived methane fueled Solid Oxide Fuel Cell

A study of mass transfer characteristics of secondary flows in a tubular solid oxide fuel cell for power density improvement

Multiphysics Simulation of a Solid Oxide Fuel Cell Based on COMSOL Method

Coupled Electrochemical-Thermo-Stress Analysis for Methanol-Fueled Solid Oxide Fuel Cells

Experimental Characterization and Elementary Reaction Modeling of Solid Oxide Electrolyte Direct Carbon Fuel Cell