Abstract:To elucidate the thermofluid reacting environment and thermal stress inside a solid oxide fuel cell (SOFC), a three-dimensional SOFC model is implemented by using the finite element method in the commercial software COMSOL Multiphysics®, which contains both a geometric model of the full-cell structure and a mathematical model. The mathematical model describes heat and mass transfer, electrochemical reactions, internal reforming reactions, and mechanical behaviors that occur within the cell. A parameter study is performed focusing on the inlet fuel composition, where humidified hydrogen and methane syngas (the steam-to-carbon ratio is 3) as well as the local distribution of temperature, velocity, gas concentrations, and thermal stress are predicted and presented. The simulated results show that the fuel inlet composition has a significant effect on the temperature and gas concentration distributions. The high-temperature zone of the hydrogen-fueled SOFC is located at the central part of units 5, 6, and 7, and the maximum value is about 44 K higher than that of methane syngas-fueled SOFC. The methane-reforming and electrochemical reactions in the anode active layer result in a significant concentration gradient between the anode support layer and the active layer of the methane syngas-fueled SOFC. It is also found that the thermal stress distributions of different fuel inlet compositions are rather different. The maximum stress variation gradient between electrode layers of hydrogen SOFC is larger (44.2 MPa) than that of methanol syngas SOFC (14.1 MPa), but the remaining components have a more uniform stress distribution. In addition, the electrode layer of each fuel SOFC produces a significant stress gradient in the y-axis direction, and stress extremes appear in the corner regions where adjacent assembly components are in contact.

Effect of Electrolyte Thickness on Electrochemical Reactions and Thermo-Fluidic Characteristics inside a SOFC Unit Cell

Towards Feasible Temperature Management and Thermo-Mechanical Stability of Carbon-Assisted Solid Oxide Electrolysis Cell

Solid Oxide Electrolysis Cell under Real Fluctuating Power Supply with a Focus on Thermal Stress Analysis

Effect of Electrolyte Thickness of Thin Film Solid Oxide Fuel Cell on Nanostructure and Performance

Identification of Restricting Parameters on Steps toward the Intermediate-Temperature Planar Solid Oxide Fuel Cell

Characteristic simulation with various anode support thicknesses of membrane electrode assembly in SOFC

Optimizing Bilayer Electrolyte Thickness Ratios for High-Performing Low-Temperature Solid Oxide Fuel Cells

Exergetic Studies of Intermediate-Temperature, Mixed Ionic-Electronic Conducting Solid Oxide Fuel Cell Electrolytes Using the Wagner Mass Transfer Model

Nanocrystal Engineering of Thin-Film Yttria-Stabilized Zirconia Electrolytes for Low-Temperature Solid-Oxide Fuel Cells

Analysis of the effect of ionic conductivity of electrolyte materials on the solid oxide fuel cell performance

Integrated modeling of electrochemical, thermal, and structural behavior in solid oxide electrolysis cells

Theoretical Modeling of Air Electrode Operating in SOFC Mode and SOEC Mode: the Effects of Microstructure and Thickness

Numerical Investigation of Heat/Flow Transfer and Thermal Stress in an Anode-Supported Planar SOFC

Characterization of electrolyte–electrode interlayers in thin film solid oxide fuel cells

Simulation and Analysis of Thermal Stress and Sintering Warpage of Planar Solid Oxide Fuel Cells

Numerical Analysis of Thermal Stress for a Stack of Planar Solid Oxide Fuel Cells

Electrophoretic Deposition in the Preparation of Electrolyte Thin Films for Solid Oxide Fuel Cells

A Numerical Investigation of the Thermal Stresses of a Planar Solid Oxide Fuel Cell

Fabrication and Characterization of Composite Electrolyte for Intermediate-Temperature SOFC

Effect of the Reactant Transportation on Performance of a Planar Solid Oxide Fuel Cell

Analyzing the thermal and electrical performance of a tubular SOFC with inserts by mass transfer coefficients