Abstract:By pulsed laser deposition (PLD) method ferroelectric BaTiO3 nanofilms were grown on Si substrates coated by nanoporous alumina membranes (NAMs) with an average pore size of 20 nm,and metal Pt nanowires were embedded in NAMs as a part of the bottom electrode. The dielectric and ferroelectric properties,and microstructure of the BaTiO3 nanofilms were characterized. The results showed that the dielectric constant of the BaTiO3 nanofilms with a thickness of 170 nm,decreased slowly from 400 to 350 as the measured frequency was increased from 103 Hz to 106 Hz,and that the dielectric loss increased slowly from 0.029 to 0.036 in the low frequency range from 103 Hz to 105 Hz,whereas quickly increased up to 0.07 at high frequencies over 105 Hz. Such a phenomenon was resulted from the dielectric dipolar polarization in the BaTiO3 nanofilms. Polarization-electric field hysteresis loop indicated that the remanent polarization and the coercive field of the BaTiO3 nanofilms were 17 μC/cm2 and 175 kV/cm,respectively. Cross-sectional (scanning) transmission electron microscopy (TEM) images demonstrated that the BaTiO3 nanofilms contacted directly with the Pt nanowires,and the interface between them had some degree of waviness. Both selected area electron diffraction and high-resolution TEM images confirmed that the BaTiO3 nanofilms were the tetragonal phase with a perovskite structure. After post-annealing and crystallization of the BaTiO3 nanofilms,some Pt nanowires became branches at their ends due to the re-growth of the Pt nanowires. A suitable post-annealing temperature is the critical processing parameter of fabricating ferroelectric ordered nanostructures as considering a trade-off between the ordered metal nanowires within NAMs and the crystallinity of ferroelectric nanofilms.

Excimer-Laser Ablating Preparation Of Ba2nanb5o15 Optical Wave-Guiding Films On (001)Ktiopo4 Substrates

Excimer Laser Ablating Preparation of Ba2NaNb5O15 Optical Waveguiding Films on (001) KTiOP04 Substrates

Excimer Laser Ablating Preparation of Ba 2 NaNb 5 O 15 Thin Films on KTiOPO 4 Substrate and Its Guide Wave Property

Excimer laser ablation of Ba2NaNb5O15 optical waveguide films on MgO(001) substrates

Preparation of optical Ba2NaNb5O15 waveguide films by pulsed laser deposition

Epitaxial Growth of Optical Ba2NaNb5O15 Waveguide Film by Pulsed Laser Deposition

Epitaxial Ba2nanb5o15 Thin-Film by Pulsed-Laser Deposition and Its Wave-Guide Properties

Study of Optical Waveguide of Barium Sodium Niobate Films on Potassium Titanyl Phosphate

Growth of LiNbO3 Optical Waveguide Films by Excimer Laser Ablation

(012) Textured LiNbO3 Waveguiding Films Grown on SiO2 by Pulsed Laser Deposition Technique

Electrophoretic Deposition and Photoluminescent Properties of Eu-doped BaTiO3thin Film from a Suspension of Monodispersed Nanocrystallites

Investigation on and preparation of the barium sodium niobate optical-waveguide films by pulsed laser deposition (PLD) technique

Synthesis of Oriented Ba2NaNb5O15 (BNN) Thin Films from an Alkoxy‐derived Precursor

Fabrication, physical property and microstructural characterization of ferroelectric BaTiO3 nanofilms

Pulsed Laser Deposition Optical Waveguiding Bi3TiNbO9 Thin Films on Fused Silica

Structure and refractive index dispersive behavior of potassium niobate tantalate films prepared by pulsed laser deposition

Excimer Laser Ablation of (001) Textured Zno Waveguiding Films on Fused Silica

Synthesis of Ba2NaNb5O15 Powders and Thin Films Using Metal Alkoxides

PULSED LASER DEPOSITION OF OPTICAL WAVEGUIDING STRONTIUM BARIUM NIOBATE FILMS

BaTiO3 Film Optical-Waveguide Prepared by Pulsed Laser Deposition

Epitaxial-Growth of Optical Wave-Guiding Litao3 Films by Excimer-Laser Ablation