Abstract:One dimensional (1D) and three dimensional (3D) ultrasound sources were applied to modulate the solidification process of FeCoCrNi2.1Al high entropy alloy whose liquidus temperature is up to 1614 K with the acoustic signal in liquid alloy in-situ measured. It was found that 1D ultrasound significantly refined the lamellar eutectic structure by decreasing both the eutectic cell width and the aligned alpha(B2)/gamma(FCC) phase spacing. If ultrasound amplitude and dimension were increased, lamellar eutectic gradually transformed into anomalous eutectic without synergetic orientation. Meanwhile, a metastable sigma phase enriched with Cr precipitated from gamma phase in anomalous eutectic under 3D ultrasounds. Based on the combined analysis of eutectic structural evolution and sound field characteristics, the ultrasonic solidification mechanism was further clarified. The promoted depen-dent nucleation by stable cavitation and the fast growth rate caused by acoustic streaming were the main reasons for the significantly refined eutectic structure under 1D ultrasound. The induced independent eutectic nucleation and growth by transient cavitation, together with the enhanced solute and thermal diffusion by the intensive acoustic streaming under 3D ultrasounds were responsible for the formation of anomalous eutectic and the precipitation of metastable sigma phase. The maximum ultimate strength and total elongation under ultrasound were simultaneously increased by 28% and 93%, showing comprehensive mechanical performance superior to those prepared by conventional approaches. The prominent strain hardening in gamma phase and increase in alpha/gamma interfaces induced by refining effect were the strengthening mechanisms, and the improvement of ductility was attributed to the intensified strain hardening in gamma phase.

Extended X-Ray Absorption Fine Structure of Metastable Bcc and Fcc Phases in Mechanically Alloyed Fe–Cu

Metastable Structures of Immiscible System Induced by Mechanical Alloying

Mechanical Alloying, Fine Structure and Thermal Decomposition of Nanocrystalline Fcc-Fe60cu40

Local Structure of Mechanically Alloyed Nanocrystalline BCC Fe80Cu20 Solid Solution

EXAFS STUDY OF THE SHORT RANGE STRUCTURE OF NANOCRYSTALLINE BCC-Fe 80 Cu 20 SOLID SOLUTION

Mechanically Driven Alloying and Structural Evolution of Nanocrystalline Fe 60 Cu 40 Powder

LOCAL STRUCTURES OF MECHANICALLY ALLOYED Fe100-xCux SOLID SOLUTIONS STUDIED BY X-RAY ABSORPTION FINE STRUCTURE

X-ray absorption fine structure and x-ray diffraction studies on structures of Fe70Cu30 alloys affected by mechanical alloying

Local Structures of Mechanical Alloying Fe70Cu30 System Studied by XAFS

Solid-State Alloying in Binary Systems with a Positive Heat of Mixing

Two-phase coexistence region in mechanically alloyed Cu–Fe: an X-ray absorption near-edge structure study

Structural Transition of Fe80Cu20 Alloy Induced by Annealing

Structural Stability and Magnetic Properties of Metastable Fe-Cu Alloys Studied Byab Initiocalculations and Molecular Dynamics Simulations

Ultrasounds Induced Eutectic Structure Transition and Associated Mechanical Property Enhancement of FeCoCrNi2.1Al High Entropy Alloy

Local Structures of Mechanically Alloyed Fe30Cu70 Binary System Studied by XAFS and XRD

The phase transition in annealed mechanically alloyed Fe - Cu.

Multi-component Phase-Field Simulation of Microstructural Evolution and Elemental Distribution in Fe–Cu–Mn–Ni–Al Alloy

Local Structures Of Mechanically Alloyed Al70cu20fe10 Nanocomposites Studied By Xrd And Xafs

Structural Studies of Nanometeric Fe100-xCux Alloys

Formation of AlCuFe icosahedral quasicrystal by mechanical alloying: XAFS and XRD studies

Mechanical Alloying of Immiscible Elements: Ag-Fe Contrasted with Cu-Fe