Abstract:The magnetic property and microstructure of as-cast FeCoNiAlx (x = 0.2, 0.4, 0.6, 0.8, 1.0) MEAs prepared by copper mold suction were investigated. For x ≤ 0.6 alloys, the soft magnetic properties monotonously decrease with increasing Al content, while a turning point of improving magnetic property occurs at x = 0.8. XRD result shows that Al addition changes the phase constitution. The alloys (x ≤ 0.4) consist of single FCC phase. FeCoNiAl0.6 (x = 0.6) and FeCoNiAl0.8 (x = 0.8) alloys are composed of FCC phase and BCC phase. FeCoNiAl1.0 (x = 1.0) alloy consists of single BCC phase. Furthermore, more serious lattice distortion is present in FCC phase than that in BCC phase. It results in the deterioration of soft magnetic property by increasing the coercivity (Hc) and the hysteresis loss (Pu), and decreasing the initial permeability (μi) and the maximum permeability (μm). The grain-boundary character distribution of FeCoNiAl0.6 (x = 0.6) alloy and FeCoNiAl0.8 (x = 0.8) alloy was studied by electron backscatter diffraction (EBSD). Less strain concentration is observed in x = 0.8 alloy than that in x = 0.6 alloy because of containing much smaller number of low angle boundaries (LAB) with a misorientation angle between 2° and 5° (5.71%) than 36.6% in x = 0.6 alloy. It leads to an improvement of soft magnetic property by decreasing the Hc, the Pu, and increasing the μi and the μm of x = 0.8 alloy. Energy dispersive spectroscopy (EDS) result shows that, in both FeCoNiAl0.6 (x = 0.6) and FeCoNiAl0.8 (x = 0.8) alloys, the enrichment of Fe and Co elements and the depletion of Ni and Al elements are observed in FCC phase, while Fe and Co elements are depleted and Ni and Al elements are enriched in BCC phase. Moreover, a close value of ferromagnetic elements, (Fe + Co + Ni)%, is obtained in FCC phase (≈85%) and BCC phase (≈78%) in both FeCoNiAl0.6 (x = 0.6) and FeCoNiAl0.8 (x = 0.8) alloys. Combined with results of EDS and magnetic properties of x = 0.6 and x = 0.8 alloys, it can conclude that the saturation magnetization (Ms) of BCC phase is larger than that of FCC phase.

Hyperfine Magnetic-Field In Mechanically Alloyed Fe-Cu

Soft Magnetism and Microwave Magnetic Properties of Fe-Co-Hf Films Deposited by Composition Gradient Sputtering

A study of electromagnetic characteristics of Fe-Si-Al magnetic alloy

Mechanical Alloying, Fine Structure and Thermal Decomposition of Nanocrystalline Fcc-Fe60cu40

X-ray absorption fine structure and x-ray diffraction studies on structures of Fe70Cu30 alloys affected by mechanical alloying

Investigation of glass forming ability, crystallization behavior, and soft magnetic properties of Fe–B–P–C–Cu alloy ribbons

Local Structures of Mechanical Alloying Fe70Cu30 System Studied by XAFS

Optimization of Crystallization Behavior and Soft Magnetic Properties of the Si-free Fe-B-P-C-Cu Nanocrystalline Alloys by Cu Content Tuning

Correlation between microstructure and soft magnetic parameters of Fe-Co-Ni-Al medium-entropy alloys with FCC phase and BCC phase

Metastable Structures of Immiscible System Induced by Mechanical Alloying

Ab Initio Studies on the Structural and Magnetic Properties of Fecu Superlattices

Structural Studies of Nanometeric Fe100-xCux Alloys

Influence of Cu Content on Structure and Magnetic Properties in Fe86-xCuxB14 Alloys

Thermal and magnetic properties of Fe(Co)BCCu amorphous alloys with high saturation magnetization of 1.77 T

LOCAL STRUCTURES OF MECHANICALLY ALLOYED Fe100-xCux SOLID SOLUTIONS STUDIED BY X-RAY ABSORPTION FINE STRUCTURE

Roles of Cu in Fe-based Soft Magnetic Nanocrystalline Alloys with High Fe Content

MAGNETOSTRICTION IN ANTIFERROMAGNETIC Fe1-xMnx(0.30 <= x <= 0.55) ALLOYS

Crystallization behavior, soft magnetic properties and good bending ductility of high Fe content FeSiBCuPC alloys induced by composition design

Mössbauer study of amorphous Fe73.5Cu1Nb3Si13.5B9 alloy

Magnetic Properties of Nanostructured Cufe2o4

Structure and Magnetic Properties of Thermodynamically Predicted Rapidly Quenched Fe85-xCuxB15 Alloys