Abstract:Age hardening at 160 degrees C was performed in an Al-6.0 wt.%Zn-2.3 wt.%Mg-I.8 wt.%Cu-0.1 wt.%Zr alloy. It was found that metastable phases played a very important role in controlling this behaviour. The alloy reached the 193 HV peak hardness aged for 6 h. Transmission electron microscopy was used to characterise the morphology of iy phases as main strengthening precipitates, and then the high-resolution transmission electron microscopy, combining with Transition Matrix calculation, was used to analysis the orientations and electron diffraction patterns of eta' precipitates. It was found that the eta' phases in four variants had only three different zone axis: [2 (4) over bar 23](eta'), [10 (1) over bar0] T and [(2) over tilde4 (2) over bar3](eta'), parallel to the [110](Al) direction of Al matrix when they were precipitated. By integrating the atomic coordinates, structure factors and double diffraction effect, a new diffraction patterns model under the [110](Al) zone axis was established, which was good in agreement with the experimental result. Simultaneously, Moire fringes analytical technique was also used to quantitatively verify the lattice parameters and orientation variants of eta' precipitates, and demonstrated that Moire fringes with about 0.7 nm spacing were the results of the interaction between the 0004(eta')/4000 (4) over bar (eta'), diffraction eta' of Ti' precipitates in variants 3/4 under the [10 (1) over bar0] y zone axis and the 1 (1) over bar (Al)/1 (1) over bar(1) over bar (Al) of Al matrix under the [110](Al) zone axis. Furthermore, the high-resolution transmission electron microscopy image simulation for Moire fringes of eta' precipitates in the Al matrix presented a good match with the experimental result. (C) 2014 Elsevier B.V. All rights reserved.

Precipitation Behaviour of Al–Zn–Mg–Cu Alloy and Diffraction Analysis from Η′ Precipitates in Four Variants

Atomic-scale study on the precipitation behavior of an Al-Zn-Mg-Cu alloy during isochronal aging

Investigation of Mechanical and Corrosion Properties of an Al–Zn–Mg–Cu Alloy under Various Ageing Conditions and Interface Analysis of Η′ Precipitate

Precipitation in an Al-Zn-Mg-Cu alloy during isothermal aging: Atomic-scale HAADF-STEM investigation

Microstructure and Mechanical Properties of Mg-Xy-1.5mm-0.4zr Alloys

Co-precipitation of T′ and η′ phase in Al-Zn-Mg-Cu alloys

Quantitative Evaluation of Precipitates in an Al–Zn–Mg–Cu Alloy after Isothermal Aging

Solute Clustering and Precipitation of Al-5.1Mg-0.15Cu-xZn Alloy

Effect of Ageing Temperature on Precipitation of Al-Cu-Li-Mn-Zr Alloy

Relationship Between the Strengthening Effect and the Morphology of Precipitates in Al–7.4Zn–1.7Mg–2.0Cu Alloy

The Precipitation Behavior and Mechanical Properties of Cast Al-4.5Cu-3.5Zn-0.5Mg Alloy

Revisiting the Precipitation Sequence in Al–Zn–Mg-based Alloys by High-Resolution Transmission Electron Microscopy

Small-angle X-ray Scattering Study of Precipitates in AlZnMgCu-1.0 Wt.% Li Alloy

Characterization of precipitates in aged Mg-4 wt%Zn alloy

Fine precipitation scenarios of AlZnMg(Cu) alloys revealed by advanced atomic-resolution electron microscopy study Part I: Structure determination of the precipitates in AlZnMg(Cu) alloys

Effect of Ag addition on the age hardening and precipitation behavior in an Al-Cu-Li-Mg-Zn-Mn-Zr alloy

Precipitation Sequence of Η Phase along Low-Angle Grain Boundaries in Al-Zn-Mg-Cu Alloy During Artificial Aging

Fine precipitation scenarios of AlZnMg(Cu) alloys revealed by advanced atomic-resolution electron microscopy study Part II: Fine precipitation scenarios in AlZnMg(Cu) alloys

Precipitation Hardening Behavior and Microstructure Evolution of Al–5.1 Mg–0.15Cu Alloy with 3.0zn (wt%) Addition

Early-stage precipitation in Al?Zn?Mg?Cu alloy (7050)

Single Stage Ageing Property And Precipitation Variation Of A High-Zinc Al-Zn-Mg-Cu Alloy