Abstract:The influence of temperature on the deformation behaviour of the C15 CaAl$_2$ Laves phase, a key constituent for enhancing the mechanical properties of Mg alloys up to service temperatures of 200 °C, remains largely unexplored. This study presents, for the first time, the nanoscale brittle-to-ductile transition (BDT) of this intermetallic phase through in situ testing including nanoindentation, scratch testing, and micropillar splitting conducted at elevated temperatures. By correlating observations from these techniques, changes in deformation of CaAl$_2$ were identified in relation to temperature. High-temperature nanoindentation quantitatively determined the temperature range for the BDT, and revealed that CaAl$_2$ undergoes a BDT at ~0.55T$_m$, exhibiting an intermediate region of microplasticity. A noticeable decrease in nanoindentation hardness was observed at ~450-500 °C, accompanied by an increase in residual indent size, while indentation cracking was not observed above 300 °C. Results from high-temperature micropillar splitting revealed cracking and brittle pillar splitting up to 300 °C, with an increase in apparent fracture toughness from 0.9 $\pm$ 0.1 MPa$\cdot\sqrt m$ to 2.8 $\pm$ 0.3 MPa$\cdot\sqrt m$, and subsequent crack-free plastic deformation from 400 °C. Transmission electron microscopy analysis of the deformed material from nanoindentation revealed that the BDT of CaAl$_2$ may be attributed to enhanced dislocation plasticity with increasing temperature.

Sample Size Induced Brittle-to-ductile Transition of Single-Crystal Aluminum Nitride

Size-Dependent Brittle-To-Ductile Transition in Silica Glass Nanofibers

Brittle-To-Ductile Transition in Multiphase Nial Alloy

Strengthening Mechanism of Aluminum Nitride Ceramics from 293 to 77 K

Study on the uniaxial tensile mechanical behavior of two-dimensional single-crystal aluminum nitride

Nanoscale brittle-to-ductile transition of the C15 CaAl$_2$ Laves phase

Size-Induced Reduction of Transition Pressure and Enhancement of Bulk Modulus of AlN Nanocrystals

Structural and mechanical properties of magnesium aluminate nanoceramics under high pressure

Size-Induced Reduction Of Transition Pressure And Enhancement Of Bulk Modulus Of A1n Nanocrystals

Size Dependence and Stochastic Nature of Yield Strength of Micron-Sized Crystals: a Case Study on Ni3Al

STUDY ON MICROSTRUCTURE AND ELEVATED TEMPERATURE MECHANICAL PROPERTY OF DIRECTIONALLY SOLIDIFIED NiAl ALLOY I. Microstructure and Brittle-to-Ductile Transition Temperature

Transformation Induced Toughening and Flaw Tolerance in Pure Nanocrystalline Aluminum

Exceptional Microscale Plasticity in Amorphous Aluminum Oxide at Room Temperature

Atomic understanding of elastic-plastic deformation and crack evolution for single crystal AlN during nanoscratch

Nanoscale Origins of the Size Effect in the Compression Response of Single Crystal Ni-Base Superalloy Micro-Pillars

Shear-induced amorphization in nanocrystalline NiTi micropillars under large plastic deformation

Fracture Toughness of Aluminum Nitride Ceramics at Cryogenic Temperatures

Ductile to Brittle Transition of Pure Al Sheet Constrained by Strength Mismatched Parallel Bi-Interface

Mechanical Annealing and Source-Limited Deformation in Submicrometre-Diameter Ni Crystals

The effect of grain boundaries and precipitates on the mechanical behavior of the refractory compositionally complex alloy NbMoCrTiAl

Ductile to Brittle Transition of Pure Al Sheet Constrained by Parallel Bi-Interface with High Strength Al Alloy