Abstract:A new method is proposed to investigate the measurement variation of instruments and their ability to discriminate two TA6V surfaces obtained by grinding with SiC grit papers (80 and 120). Three optical measurement technologies included into a single apparatus, namely Confocal Microscopy (CM), Focus Variation (FV) and Coherence Scanning Interferometry (CSI), were used to measure both ground surfaces according to a specific experimental protocol (MorphoMeca Monitoring) based on measurement iterations and repetitions. From the measurements, four indices were built from the Sa roughness parameter to assess the Quality (ratio of the topographical variability over the measurement noise), the Drift (related to surface fluctuations) and the Stability (estimation of the temporal drift using a second order autoregressive model) of the three measurement technologies (modes), as well as their Relevance (computed from an analysis of variance) to discriminate ground surfaces with close roughness. For these investigated surfaces, it was especially highlighted that the Quality Index is four times higher for the CSI mode than for the FV and CM modes. All the used measurement modes experienced small drifting (Drift Index) during the measurements. The CSI mode was slightly more sensitive to drift than the FV and CM modes. The Stability Index indicated that there was no memory effect between two acquisitions for each measurement mode, i.e., the temporal drift did not depend on the measurement mode. Moreover, the three measurement modes are able to discriminate the two ground surfaces with the same accuracy through the Sa parameter. However, the Sa values may vary depending on the measurement modes, and it was finally shown that the Sa parameter is minimized by 0.03 μm for the FV mode compared with the CSI mode, due to its smoothing effect.

Surface Roughness Measurement of Flat and Curved Machined Metal Parts Using a Near Infrared Super-Continuum Laser

A Measurement System for the Roughness of Ultra Smooth Surface with Large Aperture

Roughness Characterization of Well-Polished Surfaces by Measurements of Light Scattering Distribution

Fast Surface Measurement Using Wavelength Scanning Interferometry with Compensation of Environmental Noise

Nanometrology of an Ultraprecision Machined Surface by Using Optical Sensors

Near Common-Path Optical Fiber Interferometer for Potentially Fast On-Line Microscale-Nanoscale Surface Measurement

Measurement of the Group Refractive Index of Bulk Material Using White-Light Spectral Interferometry

Real Time Measurement of Surface Roughness Using Laser Technique

Non-Contact Surface Roughness Measurement by Implementation of a Spatial Light Modulator

A new optical technique for roughness measurement on moving surface

A Laser Heterodyne Interferometer For Measuring Surface-Roughness

Machine learning based metal surface roughness estimation in infrared images

Nanoscale surface roughness measurement based on frequency-domain interferometry principle

Portable angle-resolved scattering system to measure high spatial frequency roughness for ultra-smooth surfaces

Optical surface absolute specular reflectance measurement using an infrared etalon and interferometer combination method

A New Method for Detecting Surface Defects on Curved Reflective Optics Using Normalized Reflectivity.

In situ non-contact measurements of surface roughness

Survey of measurement methods for surface roughness

Development Of User-Friendly Software For The Roughness Measurement Of Ultra Smooth Surface

A novel methodology to assess optical profilometer stability to discriminate surface roughness

Motorized Measurement of Deformation on Surface of Revolution With 2-D Laser Profiler