Abstract:A new method is proposed to investigate the measurement variation of instruments and their ability to discriminate two TA6V surfaces obtained by grinding with SiC grit papers (80 and 120). Three optical measurement technologies included into a single apparatus, namely Confocal Microscopy (CM), Focus Variation (FV) and Coherence Scanning Interferometry (CSI), were used to measure both ground surfaces according to a specific experimental protocol (MorphoMeca Monitoring) based on measurement iterations and repetitions. From the measurements, four indices were built from the Sa roughness parameter to assess the Quality (ratio of the topographical variability over the measurement noise), the Drift (related to surface fluctuations) and the Stability (estimation of the temporal drift using a second order autoregressive model) of the three measurement technologies (modes), as well as their Relevance (computed from an analysis of variance) to discriminate ground surfaces with close roughness. For these investigated surfaces, it was especially highlighted that the Quality Index is four times higher for the CSI mode than for the FV and CM modes. All the used measurement modes experienced small drifting (Drift Index) during the measurements. The CSI mode was slightly more sensitive to drift than the FV and CM modes. The Stability Index indicated that there was no memory effect between two acquisitions for each measurement mode, i.e., the temporal drift did not depend on the measurement mode. Moreover, the three measurement modes are able to discriminate the two ground surfaces with the same accuracy through the Sa parameter. However, the Sa values may vary depending on the measurement modes, and it was finally shown that the Sa parameter is minimized by 0.03 μm for the FV mode compared with the CSI mode, due to its smoothing effect.

In situ non-contact measurements of surface roughness

Survey of measurement methods for surface roughness

Surface Form Measurement of a Small Roll Workpiece

A Study on 3D Micro-Topographical Measurement of FRCMC Grinding Surface

Nanometrology of an Ultraprecision Machined Surface by Using Optical Sensors

Design of New Type Portable 3D Roughness Measuring Instrument

Design of Surface Roughness Measurement Bench Based on Stewart Platform

Non-Contact Surface Roughness Measurement by Implementation of a Spatial Light Modulator

Reduction in Errors in Roughness Evaluation with an Accurate Definition of the S-L Surface

A Novel In-Situ Measuring Technique for Aspheric Surface

An autonomous multisensor in situ metrology system for enabling high dynamic range measurement of 3D surfaces on precision machine tools

Development of Non-contact Surface Roughness Measurement in Last Decades

Surface Form Inspection with Contact Coordinate Measurement:A Review

A novel methodology to assess optical profilometer stability to discriminate surface roughness

Surface roughness detection by tool image processing

On-machine measurement of tool nose radius and wear during precision/ultra-precision machining

Optical Measurement for Robotic Grinding and Polishing of Turbine Vanes

On-machine and in-process surface metrology for precision manufacturing

Novel Auto-Regressive Measurement of Diamond Tool Wear in Ultra-Precision Raster Milling

Research on Surface Quality Measurement Technology for Small Surface Structure

Challenges in the areal measurement of surface roughness and shape at the micro and nanoscale