Abstract:In this work, SrBi4Ti4O15 (SBT) high-temperature piezoelectric ceramics with the addition of different oxides (Gd2O3, CeO2, MnO2 and Cr2O3) were fabricated by a conventional solid-state reaction route. The effects of oxide additives on the phase structures and electrical properties of the SBT ceramics were investigated. Firstly, X-ray diffraction analysis revealed that all these oxides-modified SBT ceramics prepared presented a single SrBi4Ti4O15 phase with orthorhombic symmetry and space group of Bb21m, the change in cell parameters indicated that these oxide additives had diffused into the crystalline lattice of SBT and formed solid solutions with it. The SBT ceramics with the addition of MnO2 achieved a high relative density of up to 97%. The temperature dependence of dielectric constant showed that the addition of Gd2O3 could increase the TC of SBT. At a low frequency of 100 Hz, those dielectric loss peaks appearing around 500 °C were attributed to the space-charge relaxation as an extrinsic dielectric response. The synergetic doping of CeO2 and Cr2O3 could reduce the space-charge-induced dielectric relaxation of SBT. The piezoelectricity measurement and electro-mechanical resonance analysis found that Cr2O3 can significantly enhance both d33 and kp of SBT, and produce a higher phase-angle maximum at resonance. Such an enhanced piezoelectricity was attributed to the further increased orthorhombic distortion after Ti4+ at B-site was substituted by Cr3+. Among these compositions, Sr0.92Gd0.053Bi4Ti4O15 + 0.2 wt% Cr2O3 (SGBT-Cr) presented the best electrical properties including TC = 555 °C, tan δ = 0.4%, kp = 6.35% and d33 = 28 pC/N, as well as a good thermally-stable piezoelectricity that the value of d33 was decreased by only 3.6% after being annealed at 500 °C for 4 h. Such advantages provided this material with potential applications in the high-stability piezoelectric sensors operated below 500 °C.

Effect Of Gel-Calcination On Piezoelectric Property In (1-X)Bisco3-Xpbtio(3) Ferroelectrics

Effect of Gel-Calcination on Piezoelectric Property in (1-X)bisco3-xpbtio3 Ferroelectrics

Facile Preparation and Performance of Novel High-Tc Xbi(ni1/2ti1/2)o3-(1-x)pb(zr1/2ti1/2)o3 Piezoceramics

Bulk Dense Fine-Grain (1−x)bisco3–xpbtio3 Ceramics with High Piezoelectric Coefficient

Preparation and Characterization of (1-X)bisco<sub>3</sub>-xpbtio<sub>3</sub> Ceramics by Two-Step Sintering

Preparation and Properties of Fine‐Grain (1−x)bisco3−xpbtio3 Ceramics by Two‐Step Sintering

Enhancing Electrical Properties of High-Curie Temperature Piezoelectric Ceramics BNT-PZT and Their Mechanism

Composition Designing and Sintering Behavior Tailoring in [(ba1−xcax)0.995eu0.005](ti1−yhfy)o3 Multifunctional Piezoceramics

Preparation and Characterization on Piezo-/Ferro-electric Properties Of(1-X)(knn+lt)+xbi Ceramics

Effects of Sintering Temperature and Poling Conditions on the Electrical Properties of Ba0.70Ca0.30TiO3 Diphasic Piezoelectric Ceramics

Effect of Different Sintering Temperatures on the Electrical Properties of SBTi Ferroelectric Ceramics

Fabrication and Characterization of High Curie Temperature BiSc1/2Fe1/2O3–PbTiO3 Piezoelectric Films by a Sol–gel Process

Effect of processing temperature on structural and electrical properties of lead-free K0.5Bi0.5TiO3 piezoelectric ceramics synthesized by sol-gel technique

Preparation and Characterization of (1-x)BiScO<sub>3</sub>-xPbTiO<sub>3</sub> Ceramics by Two-Step Sintering

Enhanced Piezoelectricity in Broad Composition Range and the Temperature Dependence Research of (ba1−xcax)(ti0.95sn0.05)o3 Piezoceramics

Preparation and Characterization of (1-x)BiScO3-xPbTiO3 Ceramics by Two-Step Sintering

Grain Boundary Region and Local Piezoelectric Response of BiScO3–PbTiO3 Nanoceramics Prepared by Combination of SPS and Two-Step Sintering

Effects of Oxide Additives on the Phase Structures and Electrical Properties of SrBi4Ti4O15 High-Temperature Piezoelectric Ceramics

Effect of sintering condition and Ca2+-substitution on structural and electrical properties of lead-free Ba0.46Sr0.54TiO3 piezoceramics for uncooled IR detectors application

Phase evolution and thermal stability of high Curie temperature BiScO$_3$-PbTiO$_3$-Pb(Cd${1/3}$Nb$_{2/3}$)O$_3$ ceramics near MPB

Enhanced high-temperature piezoelectric properties of Bi(Zn0.5Ti0.5)O3-modified BiFeO3–BaTiO3 ceramics