Abstract:Abstract Mullite porous ceramics with high porosity and good mechanical properties were prepared by foaming method combined with gel casting process using kaolin and alumina as main raw materials and sodium polyoxyethylene ether sulfate as foaming agent. The effects of sintering process and magnesium oxide content on the microstructure and properties of mullite porous ceramics were investigated. The studies show that: With the addition of magnesium oxide, the amount of mullite produced and the compactness of the sample will increase. At this time, the microscopic morphology of mullite is needle-like and prismatic, and the mechanical properties are better. and the pore size distribution gradually tends to be between 0.1-0.2mm and 0.2-0.3mm. The addition of magnesium oxide, The amount of mullite phase increased, the densification degree of the sample increased, and the acicular and prismatic mullite phases with good mechanical properties were mainly formed, and the porosity of mullite porous ceramics decreased and the compressive strength increased. The pore size distribution gradually tends to be between 0.1-0.2mm and 0.2-0.3mm. As the sintering temperature increases, the porosity of mullite porous ceramics decreases and the compressive strength increases. With the extension of the holding time, the amount of mullite phase generated increases, the porosity remains basically unchanged, and the compressive strength increases.

Effects of Sintering Temperature and Porogen Addition on Properties of Low Cost Porous Mullite Ceramics

The Effects of Mineral Composition and Sintering Temperature on Synthetic Mullite

Preparation of Fly Ash-Based Porous Ceramic with Alumina as the Pore-Forming Agent

Effects of sintering temperature on properties of porous mullite/corundum ceramics

Effect Of Sintering Process On Micro-structure And Properties Of Mullite Porous Ceramics Containing magnesium oxide

Effects of Sintering Additives on Microstructure and Properties of Porous SiC Ceramics with High Porosity

A Simple and Efficient Way to Prepare Porous Mullite Matrix Ceramics Via Directly Sintering SiO2-Al2O3 Microspheres

Utilization of both Electronical Manganese Slag and Silicate Tailings as Raw Materials for Fabrication of Cost-effective Porous Ceramics

Fabrication and Properties of Porous Mullite Ceramics from Directly Sintering Ceramic Microspheres

Fabrication and Characterization of Porous Cordierite Ceramics Prepared from Fly Ash and Natural Minerals

Study on the Effect of Binders on the Properties of Mullite Porous Ceramics for Flue Gas Filtration

Fabrication and characterization of porous mullite ceramics with ultra-low shrinkage and high porosity via sol-gel and solid state reaction methods

Effects of Composite Sintering Additives: Al(OH)3+Y2O3+CaF2 on the Performance of Porous Mullite Oxide-Bonded SiC Ceramics

Effect of Sintering Temperature on Mechanical Properties of Porous Silica Ceramic

Fabrication and properties of mullite fiber-reinforced porous mullite ceramics

Study on comprehensive properties of mullite porous ceramics prepared from gangue based on sintering temperature

Effect of Sintering Temperature on Properties of Porous SiC Ceramics Produced Through Coat-mix/Composite Additives Process

Effects of Mullite Content on the Properties and Microstructure of Porous Anorthite/Mullite Composite Ceramics

Effect of pore structure evolution on mechanical properties and thermal conductivity of porous SiC-Mullite ceramics

Preparation and properties of porous ceramics from spodumene flotation tailings by low-temperature sintering

Low sintering shrinkage and high strength of porous mullite–zirconia ceramics: Effect of AlF3 and ZrSi2 contents