Abstract:This paper presents characterization and compensation of the thermal bias drift of a MEMS accelerometer whose effective stiffness is electrostatically tuned to a low value with the help of the single-sided parallel plates (SSPPs) capacitors. A temperature drift model for the proposed accelerometer is built and the temperature effect on the mechanical stiffness and the circuit gains is characterized. The characterization reveals that the variations of the feedforward coefficient including the mechanical stiffness and the readout gain due to the temperature change play a significant role in the bias drift of output of the proposed closed-loop accelerometer. On the other hand, the variations of both feedback gain and tuning gain as a function of temperature are one-order-of-magnitude less than that of the feedforward coefficient. To calibrate the feedforward coefficient, an excitation signal as a form of AC reference displacement is introduced to drive the proof mass and the readout response is demodulated to calibrate the variance of the feedforward coefficient correspondingly. An open-loop compensation scheme for the temperature-induced bias drift using the variance of the calibrated response is proposed accordingly. Alternatively, the calibrated response can be controlled to a preset value by a new proportion integral derivative (PID) controller by the adjustment of the SSPP tuning voltage. The output of the PID controller is used for the calibration of the introduced bias from the electrostatic tuning force. Therefore, a closed-loop compensation of the thermal bias drift is achieved by remaining the feedforward coefficient while eliminating the calibrated bias. Experiments under a temperature cooling process and different tuning voltages are carried out to verify two proposed compensation schemes. The temperature drift coefficients (TDCs) of both compensated outputs exhibit at least one-order-of-magnitude reduction in response to the temperature change. When the effective stiffness of the accelerometer is tuned to about 4.19 N m(-1), the TDC of the compensated output using the proposed open-loop or closed-loop compensation schemes is reduced to about 0.1136 or 0.0391 mg degrees C-1, respectively and meanwhile, the Allan bias instability is slightly increased to 48.63 or 56.14 mu g, respectively.

Improving the Dynamic Performance of Capacitive Micro-Accelerometer Through Electrical Damping

Design Of The Closed-Loop Capacitive Micro-Accelerometer Based On Pspice

Comprehensive Optimization of Pid-Type Closed-Loop Mems Accelerometer System

A Stiffness-Tunable MEMS Accelerometer

Design of Force-Balance Capacitive Accelerometer

Noise Behaviors of a Closed-Loop Micro-Electromechanical System Capacitive Accelerometer

Study of a Novel Micromachined Capacitive Accelerometer

A Low-Power Digital Processing Circuit for Capacitive Accelerometer

Temperature Bias Drift Phase-Based Compensation for a MEMS Accelerometer with Stiffness-Tuning Double-Sided Parallel Plate Capacitors

An In-Plane Low-Noise Accelerometer Fabricated with an Improved Process Flow

Investigation of a Complete Squeeze-Film Damping Model for MEMS Devices

Characterization and Compensation of Thermal Bias Drift of a Stiffness-Tunable MEMS Accelerometer

Influence of Feedback Compensation on Dynamic Property for High-Q Capacitive Accelerometers

System Damping Ratio Analysis of a Capacitive Micromechanical Accelerometer

Enhancing the Shock Response Performance of Micromachined Silicon Resonant Accelerometers by Electrostatic Active Damping Control

Improvement of Capacitive Accelerometers: Integrating Modeling, Electrode Design, Signal Processing, and Material Selection

Analysis and Prevention for Oscillation Failure of Capacitive Micro-Accelerometers

A Real-Time Temperature Compensation Algorithm for a Force-Rebalanced MEMS Capacitive Accelerometer Based on Resonant Frequency.

Study on Closed-Loop System of a Capacitive Micro-Accelerometer

Multiple-Degree-of-Freedom Modeling and Simulation for Seismic-Grade Sigma-Delta MEMS Capacitive Accelerometers

Modeling and Analysis of a Closed-Loop System for High-Q MEMS Accelerometer Sensor