Abstract:The present study investigated high-aspect ratio micro-hole array parts which were made by ZrO2 micro-powder with different particle sizes and micro-powder injection molding technology. It analysed the influence of particle sizes on feedstock, debinding and sintering of ceramic nozzles with multi-micro-holes. The forming quality of ceramic nozzles with multi-micro-holes was discussed in this paper. The results show that the two mixed ZrO2 feedstocks have fine uniformity. The average deviation of the feedstock made with 200 nm powder was −2%, and the average deviation of the feedstock made with 100 nm powder was −7.1%. The sample showed certain sintering characteristics which provided better strength (11.10 MPa) to parts after debinding. The linear shrinkage and the density of the two powder samples at different sintering temperatures increased as the sintering temperature increased. If the temperature continued to increase, the linear shrinkage and the density decreased. The highest hardness and flexural strength values of the ZrO2 sample with 200 nm powder used were: 1265.5 HV and 453.4 MPa, and the crystalline particle size was 0.36 μm. The highest hardness and flexural strength values of the ZrO2 sample with 100 nm powder used were: 1425.8 HV and 503.6 MPa, and the crystalline particle size was 0.18 μm. The ceramic nozzles with multi-micro holes shrunk to nearly the same axial, radial and circumferential directions during sintering. After sintering, the roundness of ceramic micro-hole met the user requirements, and the circular hole had a high parallelism in the axial direction. The micropore diameter was 450 ± 5 μm, and it was possible to control the dimensional accuracy within 1.5% after sintering. The study presented a superior application prospect for high-aspect ratio micro hole array parts in aerospace, electronics and biomedicine.

Preparation of ultra-high aspect ratio micro holes by casting

Preparation of U-shaped Curved Holes by a Casting Method

Micro precision casting based on investment casting for micro structures with high aspect ratio

Fabrication of Micro-Parts with High-Aspect Ratio Micro-Hole Array by Micro-Powder Injection Molding.

Microstructure of Zn-Al4 alloy microcastings by micro precision casting based on metal mold

Casting of film-cooling holes for single-crystal blades

Study on Fabrication of Ceramic Micro-device

Ultra-Long Pore Fabrication Process by Pulling–Casting in Aluminum Alloy

Micro-EDM drilling of high aspect ratio micro-holes and in situ surface improvement in C17200 beryllium copper alloy

Recent advances on precision casting of large thin wall complex castings of titanium alloys

The Design of 3D-Printed Lattice-Reinforced Thickness-Varying Shell Molds for Castings.

A novel fast and low cost replication technology for high-aspect-ratio magnetic microstructures

Towards the Ductility Limit of Large Thin-Walled A356 Alloy Castings

Technology and Development of Large Thin-wall Investment Superalloy Casting

Microfluidic Mold Insert Prepared Using a Novel Method

Fabrication of Ultrafine Nanostructures

Study on Rapid Casting for Complex Parts

A Novel Method to Fabricate High Aspect Ratio Microcoils

Study on the surface integrity of micro-holes in high volume fraction SiCp/Al using ultrasonic vibration drilling

Experimental studies on micro powder hot embossing for high-aspect-ratio microstructures with ultra-high molecular weight polyethylene powders

Research on the Cast Molding Process for High Quality PDMS Molds