Influence of Flow Rate on Different Properties of Diamond-Like Nanocomposite Thin Films Grown by PECVD
T. S. Santra,T. K. Bhattacharyya,F. G. Tseng,T. K. Barik
DOI: https://doi.org/10.1063/1.4721654
IF: 1.697
2012-01-01
AIP Advances
Abstract:Diamond-like nanocomposite (DLN) thin films were deposited on pyrex glass substrate using different flow rate of haxamethyldisiloxane (HMDSO) based liquid precursor with nitrogen gas as a glow discharged decomposition by plasma enhanced chemical vapor deposition (PECVD) technique. The significant influence of different precursor flow rates on refractive index and thickness of the DLN films was measured by using spectroscopic filmatrics and DEKTAK profilometer. Optical transparency of the DLN thin films was analyzed by UV-VIS-NIR spectrometer. FTIR spectroscopy, provides the information about shifted bonds like SiC2, Si-C, Si-O, C-C, Si-H, C-H, N-H, and O-H with different precursor flow rate. We have estimated the hardness of the DLN films from Raman spectroscopy using Gaussian deconvolution method and tried to investigate the correlation between hardness, refractive index and thickness of the films with different precursor flow rates. The composition and surface morphology of the DLN films were investigated by X-ray photo electron spectroscopy (XPS) and atomic force microscopy (AFM) respectively. We have analyzed the hardness by intensity ratio (ID/IG) of D and G peaks and correlates with hardness measurement by nanoindentation test where hardness increases from 27.8 μl/min to 80.6μl/min and then decreases with increase of flow rate from 80.6μl/min to 149.5μl/min. Finally, we correlates different parameters of structural, optical and tribological properties like film-thickness, refractive index, light transmission, hardness, surface roughness, modulus of elasticity, contact angle etc. with different precursor flow rates of DLN films.