Abstract:A novel segmented control strategy for selenization environment is introduced to regulate the selenization reaction by controlling the evaporation area of Se. This selenization method helps to promote element homogenization, optimize surface smoothness, and obtain a high‐crystalline‐quality absorber with low‐point defects. And the CZTSSe solar cell with a PCE of 13.77% is successfully achieved. High‐crystalline‐quality absorbers with fewer defects are crucial for further improvement of open‐circuit voltage (VOC) and efficiency of Cu2ZnSn(S,Se)4 (CZTSSe) solar cells. However, the preparation of high‐quality CZTSSe absorbers remains challenging due to the uncontrollability of the selenization reaction and the complexity of the required selenization environment for film growth. Herein, a novel segmented control strategy for the selenization environment, specifically targeting the evaporation area of Se, to regulate the selenization reactions and improve the absorber quality is proposed. The large evaporation area of Se in the initial stage of the selenization provides a great evaporation and diffusion flux for Se, which facilitates rapid phase transition reactions and enables the attainment of a single‐layer thin film. The reduced evaporation area of Se in the later stage creates a soft‐selenization environment for grain growth, effectively suppressing the loss of Sn and promoting element homogenization. Consequently, the mitigation of Sn‐related deep‐level defects on the surface and in the bulk induced by element imbalance is simultaneously achieved. This leads to a significant improvement in nonradiative recombination suppression and carrier collection enhancement, thereby enhancing the VOC. As a result, the CZTSSe device delivers an impressive efficiency of 13.77% with a low VOC deficit.

Spatial Element Distribution Control in a Fully Solution-Processed Nanocrystals-Based 8.6% Cu 2 ZnSn(S,Se) 4 Device

Toward High Performance Cu2ZnSn(S,Se)4 Solar Cells Through Nanocrystal Precursors

Novel solution processing of high-efficiency Earth-abundant Cu2 ZnSn(S,Se)4 solar cells.

Understanding the Key Factors of Enhancing Phase and Compositional Controllability for 6% Efficient Pure-Sulfide Cu2znsns4 Solar Cells Prepared from Quaternary Wurtzite Nanocrystals

CZTS nanocrystals: a promising approach for next generation thin film photovoltaics

Surprising Efficiency Enhancement of Cu2ZnSn(S,Se)4 Solar Cells with Abnormal Zn/Sn Ratios

Rational Defect Passivation of Cu2ZnSn(S,Se)4 Photovoltaics with Solution-Processed Cu2ZnSnS4:Na Nanocrystals.

Segmented Control of Selenization Environment for High‐Quality Cu2ZnSn(S,Se)4 Films Toward Efficient Kesterite Solar Cells

Eliminating Cracking Morphology of Solution-Processed CZTSSe Absorbers by Sn-rich Composition Engineering

Surprising Efficiency Enhancement of Cu 2 ZnSn(S,Se) 4 Solar Cells with Abnormal Zn/Sn Ratios

Controlling Solid-Gas Reactions at Nanoscale for Enhanced Thin Film Morphologies and Device Performances in Solution-Processed Cu2ZnSn(S,Se)4 Solar Cells

Realization of Grain Growth and Suppressed Bulk Defects for Efficient Solution-Processed Cu2ZnSn (S, Se)4 Solar Cells Via Co-Doping Strategy

Benign Solutions and Innovative Sequential Annealing Processes for High Performance Cu2ZnSn(Se,S)4 Photovoltaics

Controlling selenization equilibrium enables high-quality Cu2ZnSn(S, Se)4 absorbers for efficient solar cells

Passivating SnZn Defect and Optimizing Energy Level Alignment via Organic Silicon Salt Incorporation toward Efficient Solution‐Processed CZTSSe Solar Cells

Facile single-component precursor for Cu2ZnSnS4 with enhanced phase and composition controllability

Open-air Solvothermal Synthesis and Photoresponse of Plate-Shaped Cu3ZnInSnSe6 Nanocrystals

Se as hetero-nucleation seeds reinforcing intermetallic diffusion for improved electrodeposition-processed CZTS solar cells

Advances In Cu2znsn(S,Se)(4) Thin Film Solar Cells

Mild Solvothermal Synthesis of Cu2ZnSn(SxSe1−x)4 Nanocrystals with Tunable Phase Structure and Composition

Effects of Selenization Conditions on Microstructure Evolution in Solution Processed Cu2ZnSn(S,Se)(4) Solar Cells