Abstract:Mechanical behavior of film material in micron and nano scales has gained much consideration as it has been extensively used in microelectronics and Microelectromechanical Systems (MEMS). Many works have been carried out to investigate the mechanical properties of film material by undergoing uniaxial micro-tension testing where the micro-tension setups used by many authors are mainly the uniaxial tension in a unique direction. But when these setups are used under a microscopic system, the micro regions being detected often go beyond the scanning scope during the test. This brings in difficulty to accurately calculate the deformations of the detected regions. In this paper, a delicate setup which can accomplish uniaxial tension in the opposing directions and micro force detection is designed to investigate the in-situ microstructure evolution of specimens under loading. Two identical piezoelectric actuators moving in the opposing direction are used to exert forces on the specimen synchronously controlled by a computer. Two symmetrical double-cantilevered force sensors respectively connected to the two PZT actuators are devised to detect the tensile loads applied on the specimen. The force sensors are calibrated using Electronic Speckle Pattern Interferometry (ESPI). The relative gripping and adjusting units located between the double-cantilevered force sensors are employed to ensure that the specimen is under uniaxial load. The proposed tensile setup can be used under an optical microscopic or an AFM stage for studying the morphology changes and deformations of material on grain scale. The elaboration of the system is presented in the paper and an experiment of polycrystalline aluminum thin film deformations based on grain scale is performed to demonstrate its performance.

A Tension-Torsional Fatigue Testing Apparatus For Micro-Scale Components

A Miniaturized Biaxial Tensile Apparatus Based on Torsional Loading Design

Multi-scale Deformation Behavior Investigation of 18cr–8ni Austenitic Steel Subjected to Low-Cycle Fatigue Loading

A Novel Torsion Testing Technique for Micro-Scale Specimens Based on Electromagnetism

Research of Load Cell with Low-Torque/High-Tensile Traction

Ratcheting of 316L Stainless Steel Thin Wire under Tension-Torsion Loading

Developing of a Stiffness Testing System of Micro-torsion Spring

Minitype tension-torsional fatigue test machine and study on nonproportional cyclic behaviors of solder

Design of a Novel Tensile Testing Device and Its Application in Tensile Testing Experiments on Copper Micro Wires

An Off-chip Actuated Tensile Test Device for Microscale Mechanical Testing

Characterizing Torsional Properties of Microwires Using an Automated Torsion Balance

Design of a Micro Tensile Testing Structure to Restrain Non-Axial Alignment Errors

Realization of Tensile-Bending Mechanical-Thermal Coupling Fatigue Based on a Uniaxial Tensile-Fatigue Testing Device

An Apparatus for Measuring Mechanical Properties of Microstructures in Tensile Mode

A unified multi-axial sub-micron fatigue tester with applications to electronic packaging materials

Effect of Torsion Angle on Tension-Torsion Multiaxial Fretting Fatigue Behaviors of Steel Wires

Development of Miniature Tensile-Test System of Intermediate Strain Rate Based on Electromagnetic Launch

OS5-2-3 an In-Situ Micro-Tension Setup and Its Application

An Experimental Method for Micro-Scale Uniaxial Tension Test

A New Torsion Tester Based on an Electronic Autocollimator for Characterizing the Torsional Behaviors of Microfibers.

Torsional Fatigue With Axial Constant Stress Of Oligo-Crystalline 316l Stainless Steel Thin Wire