Abstract:Accurate mechanical properties measurements in the micro scale are very important for the design and the fail-safe analysis of MEMS. And the tensile test, as one of the micromechanical experimental techniques, has the advantage of uniform stress and strain fields. In this paper, a new tensile testing structure is presented to solve the non-axial alignment problem in microscale tensile test. The testing structure integrates the specimen and the suspended spring beams on a chip. The function of the additional spring beams is to balance the non-axial loading component and so the specimen is uniaxial tensile. As the spring constant of the tensile specimen in the axial direction is much smaller than the spring constant of the testing structure in the vertical direction, the spring beams could specimen caused by non-axial force. Meanwhile, the spring constant of the specimen in axial direction is much larger than that of the spring beams in the same direction so that the loading shared in the spring beams can be ignored. The performance of the tensile testing structure is confirmed by FE simulations. When the loading force has 2° angle with the axial direction, the stress distribution of the specimen is almost identical with that of under axial loading. The axial stress of the specimen is considerably uniform. That is to say the specimen is uniaxially tensile, although the loading direction is offset the axial. And the force shared in the suspended spring beams is below 3.2% of the loading force. The tensile testing structure could greatly weaken the errors caused by disalignment, and would have big potential to be used in the microscale tensile test.

Minitype tension-torsional fatigue test machine and study on nonproportional cyclic behaviors of solder

Characterization of Dynamic Behavior of Pb-free Material 95.7sn3.8ag0.5cu and Its Determination of Dynamic Constitutive Model Parameters

Cyclic Tensile Machine with Wide Speed Range for in Situ Neutron/x-Ray Scattering Study on Elastomers

A unified multi-axial sub-micron fatigue tester with applications to electronic packaging materials

Inelastic Deformation and Fatigue of Solder Alloys under Complicated Load Conditions

A Thermomechanical Constitutive Model for Investigating the Fatigue Behavior of Sn‐rich Solder under Thermal Cycle Loading

Tbiaxial Tension Test of Soft Materials

Anand Parameter Test for Pb-Free Material SnAgCu and Life Prediction for a CSP

A Novel Integrated Tension-Compression Design for A Mini Split Hopkinson Bar Apparatus

Monotonic and fatigue testing of spring-bridged freestanding microbeams application for MEMS

An Experimental Study of the Superelastic Behavior in NiTi Shape Memory Alloys under Biaxial Proportional and Non-Proportional Cyclic Loadings

Design of a Novel Tensile Testing Device and Its Application in Tensile Testing Experiments on Copper Micro Wires

Realization of Tensile-Bending Mechanical-Thermal Coupling Fatigue Based on a Uniaxial Tensile-Fatigue Testing Device

Study of Thin-plate Specimen Fixture of High-frequency Fatigue Testing Machine

Dynamic Simulation Analysis of the Mid-Strain-Rate Tensile Testing Machine

Biaxial Tensile Behavior of Ti-6Al-4V under Proportional Loadings at High Strain Rates

Design of a Micro Tensile Testing Structure to Restrain Non-Axial Alignment Errors

Research of Load Cell with Low-Torque/High-Tensile Traction

Experimental and numerical investigation of combined isotropic-kinematic hardening behavior of sheet metals

An Off-chip Actuated Tensile Test Device for Microscale Mechanical Testing

Study of Off-Chip Tensile Test Experimental Facility for Micro-Component Mechanical Property