Abstract:Accurate mechanical properties measurements in the micro scale are very important for the design and the fail-safe analysis of MEMS. And the tensile test, as one of the micromechanical experimental techniques, has the advantage of uniform stress and strain fields. In this paper, a new tensile testing structure is presented to solve the non-axial alignment problem in microscale tensile test. The testing structure integrates the specimen and the suspended spring beams on a chip. The function of the additional spring beams is to balance the non-axial loading component and so the specimen is uniaxial tensile. As the spring constant of the tensile specimen in the axial direction is much smaller than the spring constant of the testing structure in the vertical direction, the spring beams could specimen caused by non-axial force. Meanwhile, the spring constant of the specimen in axial direction is much larger than that of the spring beams in the same direction so that the loading shared in the spring beams can be ignored. The performance of the tensile testing structure is confirmed by FE simulations. When the loading force has 2° angle with the axial direction, the stress distribution of the specimen is almost identical with that of under axial loading. The axial stress of the specimen is considerably uniform. That is to say the specimen is uniaxially tensile, although the loading direction is offset the axial. And the force shared in the suspended spring beams is below 3.2% of the loading force. The tensile testing structure could greatly weaken the errors caused by disalignment, and would have big potential to be used in the microscale tensile test.

Study of Off-Chip Tensile Test Experimental Facility for Micro-Component Mechanical Property

An Off-chip Actuated Tensile Test Device for Microscale Mechanical Testing

An Apparatus for Measuring Mechanical Properties of Microstructures in Tensile Mode

Design of a Micro Tensile Testing Structure to Restrain Non-Axial Alignment Errors

A Thermal Actuated Test Platform for in Situ Evaluating the Tensile Fracture Strength of Micro-Structures

Design of a Novel Tensile Testing Device and Its Application in Tensile Testing Experiments on Copper Micro Wires

On the Mechanical Properties in Micro-Tensile Testing of Single Fiber

Design and fabrication of a micron scale free-standing specimen for uniaxial micro-tensile tests

The Development and Testing Research of Impact Tensile Testing Apparatus

Design of Tensile Device of Nanomaterials and Quantitative Analysis

A Tension-Torsional Fatigue Testing Apparatus For Micro-Scale Components

Mechanical Characterization of Flat Specimens in Tensile Test and Numerical Simulation

A Micro-Tensile Testing Chip–integrated Piezoresistive Cells for Tension Measurement and Axial Alignment

A New Method of Tensile Performance Testing for Materials at High Temperature and High Strain Rate

A Universal Structure for Self-Aligned in Situ On-Chip Micro Tensile Fracture Strength Test

Design of testing chip for measuring mechanical properties of thin films

A New Micro-Tensile System for Measuring the Mechanical Properties of Low-Dimensional Materials - Fibers and Films

A Compact Microstructure Mechanical Property Measuring System

A Dual-Parameter On-Chip Test Platform Based on Thermal Actuator for Testing Fracture Strength of Microstructure

A Novel Micro Tensile Testing Instrument with Replaceable Testing Specimen by Parylene Passivation Technique

A New Method for the Micro-Tensile Testing of Thin Film