Abstract:Ultrasonic fatigue testing is a key technology that is more efficient and energy saving compared to conventional fatigue testing. In order to investigate the behavior of metallic materials at ultra-high frequencies and to verify the validity of ultrasonic fatigue test results, this paper builds a test apparatus that can be used to conduct ultrasonic fatigue tests, and this paper proposes a complete procedure from theoretical analysis to the investigation of test laws for 20 kHz tensile and the compression test. Firstly, the initial sizes of the sample are calculated with an analytical method, then the three-dimensional model is simulated and optimized with finite element software, and the optimum result for the sample size is then obtained according to the sensitivity of the sample size to the effect of frequency. The next step is to analyze the influenced trend of the sample size, including L1, L2, L3, R1 and R2, on the resonant frequency and maximum stress of the sample. According to the optimized results, the sample was processed, and an ultrasonic fatigue test was carried out to ensure the sample fatigue fracture finally occurred. Finally, the S-N curve of the material was plotted based on the data recorded in the test and compared with the conventional fatigue life curve to verify the feasibility of the ultrasonic fatigue test device and test method. The fracture of the sample was observed using an optical microscope, and its macroscopic fracture morphology was analyzed. The fracture morphology of the sample can be divided into three typical zones: the fatigue crack source zone, the extension zone and the transient zone, where the fatigue cracks all originate from on the surface of the sample. The results demonstrate the validity of the ultrasonic fatigue test results and provide new ideas for the design and optimization of ultrasonic fatigue samples and shorter processing times, providing a reference for subsequent ultrasonic fatigue tests on typical materials.

The Development and Testing Research of Impact Tensile Testing Apparatus

Development of Structural Testing Equipment for Impact and Complex Loading

Development of Static and Dynamic Test of Steel Beam Reinforced by External Prestressed Force

Dynamic Testing of Materials with the Rotating Disk Indirect Bar-Bar Tensile Impact Apparatus

Testing Machine for Testing Durability of Material under High-Pressure Hydrogen Circumstance

A complete three-dimensional finite element analysis of the bar-bar tensile impact apparatus

3-D Dynamic Elastic–plastic FEA for Rotating Disk Indirect Bar–bar Tensile Impact Apparatus: Numerical Analysis for the Generation of Mechanically-Filtered Incident Stress Pulses

A Novel Integrated Tension-Compression Design for A Mini Split Hopkinson Bar Apparatus

Design and Implementation of Testing Device for Damping Oil Bulk Modulus and Fatigue Characteristic

Development of the High-speed Sliding-rolling Contact Friction Testing Machine

Development of Multi-work Condition Declivitous Impact Testing System

An Automatic Three-Dimensional Loading Apparatus for Static Tests of Truss Joints

Biaxial Tension Test of Soft Materials

Experimental Study of 20# Steel under Tensile Impact

Development of Research on Dynamic Mechanical Properies of Joints

Effect of the Geometric Shapes of Specimens on Impact Tensile Tests

Development of an Instantaneous Loading Impact Test System for Containment of a Nuclear Power Plant during Aircraft Impact on Steel Bar Joints

On the Development of New Test Techniques to Measure the Tensile Response of Materials at High and Ultra-high Strain Rates

An Apparatus for Measuring Mechanical Properties of Microstructures in Tensile Mode

Experimental Technique of High Strain-Rate Tension Based on Hopkinson Bar

Design Theory and Experimental Research of Ultrasonic Fatigue Test