Abstract:Electrochemical deposition (ED) has been proposed as a low temperature approach for preparing hydroxyapatite (HA) coatings. To overcome the problem of low adhesion, the preparation of thin and low-porosity coatings on Ti substrates pre-treated by micro-arc oxidation (MAO) is a good strategy. In this paper, a thin and dense HA coating was obtained by modifying parameters at pH 6.4, 45 °C, and 0.5 mA·cm −2 . The growth behaviours of HA electrodeposited on MAO coatings were investigated by SEM and EDS technology and summarized that the HA was initially generated in the MAO micropores, then covered the entire MAO surface and gradually grew outwards. This growth pattern was also confirmed by ATR-FTIR, XPS, EIS, open potential, and wettability results at different ED cycles. Adjusting 1:1 power-on/off time ratio affected the morphology of HA grown in the pores in the early stage and also increased the interfacial strength, up to 10.69 MPa at duty cycle 12/24.The cross-section of the final specimen was characterised by TEM and EDS, indicating that amorphous layers, nanocrystalline HA, and submicron HA were formed sequentially from the TiO 2 (Ca)/HA interface outwards. The increase in Ca 2+ concentration and the formation of CaO bonds at the interface may be important reasons for the adhesive enhancement. This process provides a strategy to enhance the strength of bioceramic materials on Ti substrates.

Effect of Na+ and NaOH concentrations on the surface morphology and dissolution behavior of hydroxyapatite

Effect of Trisodium Citrate on Electrolytic Deposition of Hydroxyapatite Coatings

Synthesis and Charaterization of Silicon-Substituted Hydroxyapatite Coating by Electrochemical Deposition on Ti Substrate

Electrodeposition of Hydroxyapatite Coating on CoNiCrMo Substrate in Dilute Solution

Synthesis and Characterization of Zn-substituted Hydroxyapatite Coatings by Electrochemical Deposition

Effect of Supersaturation on the Morphology of Hydroxyapatite Crystals Deposited by Electrochemical Deposition on Titanium

The effect of NaOH concentration on the steam-hydrothermally treated bioactive microarc oxidation coatings containing Ca, P, Si and Na on pure Ti surface.

A Study of the Process and Kinetics of Electrochemical Deposition and the Hydrothermal Synthesis of Hydroxyapatite Coatings

[In Vitro Dissolution Study on the Hydroxyapatite Biocoatings].

Preparation and biological evaluation of Nano-HA coating on tatinium surfaces

Effect of Current Density Changes on the Properties of Hydroxyapatite Biocoatings

Effect of Methyl and Hydroxyl Functional Group Surfaces on Crystallization of Hydroxyapatite Coating

Effect of Alkali Treatments on Apatite Formation of Microarc-Oxidized Coating on Titanium Alloy Surface

Recent advances in multifunctional hydroxyapatite coating by electrochemical deposition

Effect of hydroxyapatite coating crystallinity on dissolution and osseointegration in vivo.

Effect of hydrothermal treatment temperature on the hydroxyapatite coatings deposited by electrochemical method

Study of Process and Properties of the Hydroxyapatite Biocoatings Fabricated by Electrocrystallization and Hydrothermal Synthesis

The Effects of NaOH Concentration on the Hydrothermal Synthesis of a Hydroxyapatite–Zeolite Composite Using Blast Furnace Slag

Effect of SiC Particle Contents and Size on the Microstructure and Dissolution of SiC-Hydroxyapatite Coatings

Preparation and growth behaviours of low porosity hydroxyapatite with enhanced adhesion by electrochemical deposition on micro-arc oxide coatings

Effect of Heat Treatment of Nano-Hydroxyapatite Coatings Prepared Using Electrohydrodynamic Deposition