Abstract:Electrochemical deposition (ED) has been proposed as a low temperature approach for preparing hydroxyapatite (HA) coatings. To overcome the problem of low adhesion, the preparation of thin and low-porosity coatings on Ti substrates pre-treated by micro-arc oxidation (MAO) is a good strategy. In this paper, a thin and dense HA coating was obtained by modifying parameters at pH 6.4, 45 °C, and 0.5 mA·cm −2 . The growth behaviours of HA electrodeposited on MAO coatings were investigated by SEM and EDS technology and summarized that the HA was initially generated in the MAO micropores, then covered the entire MAO surface and gradually grew outwards. This growth pattern was also confirmed by ATR-FTIR, XPS, EIS, open potential, and wettability results at different ED cycles. Adjusting 1:1 power-on/off time ratio affected the morphology of HA grown in the pores in the early stage and also increased the interfacial strength, up to 10.69 MPa at duty cycle 12/24.The cross-section of the final specimen was characterised by TEM and EDS, indicating that amorphous layers, nanocrystalline HA, and submicron HA were formed sequentially from the TiO 2 (Ca)/HA interface outwards. The increase in Ca 2+ concentration and the formation of CaO bonds at the interface may be important reasons for the adhesive enhancement. This process provides a strategy to enhance the strength of bioceramic materials on Ti substrates.

A Study of the Process and Kinetics of Electrochemical Deposition and the Hydrothermal Synthesis of Hydroxyapatite Coatings

Synthesis and Characterization of Zn-substituted Hydroxyapatite Coatings by Electrochemical Deposition

Effect of Supersaturation on the Morphology of Hydroxyapatite Crystals Deposited by Electrochemical Deposition on Titanium

Synthesis and Charaterization of Silicon-Substituted Hydroxyapatite Coating by Electrochemical Deposition on Ti Substrate

Effect of EDTA on Electrodeposition of Hydroxyapatite Coatings

Morphologies of Hydroxyapatite Crystal Deposited on Titanium Surface with Electrochemical Technique

Electrolytic Deposition of Magnesium-Substituted Hydroxyapatite Crystals on Titanium Substrate

A Novel Method to Synthesize Hydroxyapatite Coating with Hierarchical Structure

Ribbon-like and rod-like hydroxyapatite crystals deposited on titanium surface with electrochemical method

Electrodeposition of Hydroxyapatite Coating on CoNiCrMo Substrate in Dilute Solution

Effect of Trisodium Citrate on Electrolytic Deposition of Hydroxyapatite Coatings

Synthesized Silicon-Substituted Hydroxyapatite Coating on Titanium Substrate by Electrochemical Deposition

Evolution of the magnesium incorporated amorphous calcium phosphate to nano-crystallized hydroxyapatite in alkaline solution

Hydrothermal synthesis of nano-hydroxyapatite crystals

Study of Process and Properties of the Hydroxyapatite Biocoatings Fabricated by Electrocrystallization and Hydrothermal Synthesis

Recent advances in multifunctional hydroxyapatite coating by electrochemical deposition

Characterisation of hydroxyapatite bio-coatings processed by electrocrystallisation technique

Morphology and Composition of Hydroxyapatite Coatings Prepared by Hydrothermal Treatment on Electrodeposited Brushite Coatings.

Preparation and growth behaviours of low porosity hydroxyapatite with enhanced adhesion by electrochemical deposition on micro-arc oxide coatings

Processing and in vitro behavior of hydroxyapatite coatings prepared by electrostatic spray assisted vapor deposition method

Electrohydrodynamic Coating of Metal with Nano-Sized Hydroxyapatite.