Abstract:Tellurium and its alloys are used in many applications such as photoconductors, piezoelectric devices, thermoelectric generators and coolers [1]. For thermoelectric applications, the transport properties (thermal conductivity, electrical resistivity, Seebeck coefficient) of tellurium and its compounds can be improved by nanostructuring [2]. One-dimensional nanostructures like nanowires [3] and core-shell nanowires [4] are particularly promising due to the high phonon interface scattering and the blocking of the phonon conduction along the wire axis which lead to an increase of the thermoelectric conversion efficiency. Te nanowires can represent a base to create core-shell structures, being the core that could be further capped with a shell to get arrays of Te-based thermoelectric nanostructures like BiTe [5], AgTe [6] or LaTe [7]. Template assisted electrodeposition is a low cost technique widely used in literature for the synthesis of nanowires but implies several preparation steps and the removal of the template after the growth of the nanowires. The aim of this work is to develop a template free synthesis route that would be more convenient. For this purpose, Room-Temperature Ionic Liquids (RTILs) appear as promising solvents. Indeed, it has been highlighted that they can act as stabilizing agents for nanoparticles and nanostructured films synthesis [8]. In a previous work ([9]), our laboratory showed that Te nanowires can be obtained in an ionic liquid binary mixture: 1-ethyl-1-octyl-piperidinium bis(trifluoromethylsulfonyl)imide:1-ethyl-1-octyl-piperidinium bromide (EOPipTFSI:EOPipBr). In the present work, several morphologies were obtained by varying the synthesis parameters (applied fixed potential, Te(IV) concentration, electrolyte composition). Under charge transfer control, micrometer faceted grains are formed. Under diffusion control, the deposits are composed of nanowires, which are single crystalline as proven by SAED (Selected Area Electronic Diffraction) and TEM (Transmission Electron Microscopy) analyses. In highest tested overpotential conditions, nanowires turn progressively into crystallized hollow nanostructures (HNs) when the coulometric charge increases. This phenomenon is more accentuated at low concentration and disappears when using a soluble anode, showing that the formation of HNs is due to a limitation by species supply. The geometry of HNs, with a high surface to volume ratio, is particularly interesting to create high performances thermoelectric materials. Indeed, this geometry could further decrease the lattice part of the thermal diffusion coefficient by phonon confinement. By decreasing the bromide content of the electrolyte, hair-like single crystalline nanowires with a high aspect ratio can be obtained. HRTEM (High Resolution Transmission Electron Spectroscopy) analyses reveal a growth along the c -axis, with a smooth interface. No surface contaminants were observed by STEM (Scanning Transmission Electron Microscopy), proving that halogenide ions do not play the role of capping agents, unlike observed in other works [10]. References [1] Q. Wang et al, Adv. Mater. 2013 , 25 , 3915 [2] K.T. Kim et al, Adv. Powder Technol. 2011 , 22 , 566 [3] Caballero-Calero, O.; Martín-González, M., Scripta Materialia 2015, 10.1016/j.scriptamat.2015.04.020. [4] Poon, S. J.; Petersen, A. S.; Wu, D. Appl. Phys. Lett. 2013 , 102 . [5] Kang, J.; Roh, J. W.; Shim, W.; Ham, J.; Noh, J. S.; Lee, W. Advanced Materials 2011 , 23 , 3414. [6] Fang, H. Y.; Yang, H. R.; Wu, Y. Chemistry of Materials 2014 , 26 , 3322. [7] May, A. F.; Fleurial, J. P.; Snyder, G. J. Phys. Rev. B 2008 , 78 . [8] Z. Li et al, Current Opinion in Solid State and Materials Science 2008 , 12 , 1 [9] J. Szymczak et al., Electrochem. Comm. 2012 , 24 , 57 [10] Al-Salman, R.; Sommer, H.; Brezesinski, T.; Janek, J. Chemistry of Materials 2015 , 27 , 3830. Figure 1: SEM (a) and HRTEM (b) images of Te nanostructures electrodeposited in EOPipTFSI ionic liquid Figure 1

Large-Scale Fabrication of Tellurium Nanowire Arrays by Magnetron Sputtering with Controllable Morphology

Possible role for Ca2+-dependent arachidonate release and prostaglandin synthesis in expression of the action of osmolality on renal inner medullary cGMP.

Site-Specific Nucleation and Controlled Growth of A Vertical Tellurium Nanowire Array for High Performance Field Emitters

1D Tellurium Nanostructures: Photothermally Assisted Morphology-Controlled Synthesis and Applications in Preparing Functional Nanoscale Materials

Toward a Procedure for the Template Free Growth of Te Nanowires Across an Insulator by Electrodeposition

Two cases of Robertsonian translocations in oligozoospermic males and their consequences for pregnancies induced by intracytoplasmic sperm injection.

First sub-kilogram-scale synthesis of high quality ultrathin tellurium nanowires

Tuning the Morphology of Te 1D Nanostructures By Template-Free Electrochemical Deposition in an Ionic Liquid

An Efficient Templating Approach for Synthesis of Highly Uniform CdTe and PbTe Nanowires.

Silicon nano-wires grown at low temperature

Rapid Microwave-Assisted Synthesis of Uniform Ultralong Te Nanowires, Optical Property, and Chemical Stability

G030084 Fabrication of High Density Cu Nanowire Array by Template Method and Its Evaluation

Direct Fabrication of Tellurium/Carbon Nanocables Through a Facile Solution Route

Selenium Nanotubes Synthesized by A Novel Solution Phase Approach

Large-scale and highly ordered 1D nanostructural arrays by template-assisted electrodeposition

A Green Chemical Approach To The Synthesis Of Tellurium Nanowires

Fabrication of Silicon Nanowire Arrays with Controlled Diameter, Length, and Density

A Novel Ultrasonic-Assisted Solution-Phase Approach For The Fabrication Of Tellurium Bundles Of Nanowhiskers

Formation of Magnetic Nanowire Arrays by Cooperative Lateral Growth.

Transformation Mechanism of Te Particles into Te Nanotubes and Nanowires During Solvothermal Process

Self-extrusion of Te Nanowire from Si–Sb–Te Thin Films