Abstract:This work presents the development of novel IBC‐SHJ solar cells with a MoOx blanket layer aiming to simultaneously enable a simplified device processing and a high shunt resistance in the device. The fabricated solar cells exhibit efficiencies up to 21.14% with high shunt resistances above 150 kΩcm2. The fabrication process of interdigitated‐back‐contacted silicon heterojunction (IBC‐SHJ) solar cells has been significantly simplified with the development of the so‐called tunnel‐IBC architecture. This architecture utilizes a highly conductive (p)‐type nanocrystalline silicon (nc‐Si:H) layer deposited over the full substrate area comprising pre‐patterned (n)‐type nc‐Si:H fingers. In this context, the (p)‐type nc‐Si:H layer is referred to as blanket layer. As both electrodes are connected to the same blanket layer, the high lateral conductivity of (p)nc‐Si:H layer can potentially lead to relatively low shunt resistance in the device, thus limiting the performance of such solar cells. To overcome such limitation, we introduce a thin (<2 nm) full‐area molybdenum oxide (MoOx) layer as an alternative to the (p)nc‐Si:H blanket layer. We demonstrate that the use of such a thin MoOx minimizes the shunting losses thanks to its low lateral conductivity while preserving the simplified fabrication process. In this process, a novel (n)‐type nc‐Si:H/MoOx electron collection contact stack is implemented within the proposed solar cell architecture. We assess its transport mechanisms via electrical simulations showing that electron transport, unlike in the case of tunnel‐IBC, occurs in the conduction band fully. Moreover, the proposed contact stack is evaluated in terms of contact resistivity and integrated into a proof‐of‐concept front/back‐contacted (FBC) SHJ solar cells. Contact resistivity as low as 100 mΩcm2 is achieved, and fabricated FBC‐SHJ solar cells obtain a fill factor above 81.5% and open‐circuit voltage above 705 mV. Lastly, the IBC‐SHJ solar cells featuring the MoOx blanket layer are fabricated, exhibiting efficiencies up to 21.14% with high shunt resistances above 150 kΩcm2. Further optimizations in terms of layer properties and fabrication process are proposed to improve device performance and realize the efficiency potential of our novel IBC‐SHJ solar cell architecture.

GZO/IWO stacks with enhanced lateral transport capability for efficient and low cost SHJ solar cells

Gallium‐Doped Zinc Oxide/Tungsten‐Doped Indium Oxide Stacks with Enhanced Lateral Transport Capability for Efficient and Low‐Cost Silicon Heterojunction Solar Cells

Highly Efficient Silicon Heterojunction Solar Cells with ZnO:Al Transparent Electrode and Transition Metal Doped Indium Oxide Interfacial Layer

Application of Indium Tin Oxide/Aluminum-Doped Zinc Oxide Transparent Conductive Oxide Stack Films in Silicon Heterojunction Solar Cells

Ga-doped ZnO rear transparent contact enables high efficiency silicon heterojunction solar cells

ZnO‐doped In2O3 front transparent contact enables >24.0% silicon heterojunction solar cells

ZnO-Doped In<sub>2</sub>O<sub>3</sub> Front Transparent Contact Enables >24.0% Silicon Heterojunction Solar Cells

Room-temperature Sputtered Tungsten-Doped Indium Oxide for Improved Current in Silicon Heterojunction Solar Cells

Enhancement of Short-Circuit Current Density in Silicon Heterojunction Solar Cells by Hydrogenated Multiple-Doped In2O3 Thin Films

Realization of SiOx/SiNx Stacks As Multi Anti-Reflection Coatings and Selectively Copper-plating Mask for Silicon Heterojunction Solar Cell with 23.5% Efficiency

Interdigitated‐back‐contacted silicon heterojunction solar cells featuring novel MoOx‐based contact stacks

Innovative Wide-Spectrum Mg and Ga-Codoped ZnO Transparent Conductive Films Grown Via Reactive Plasma Deposition for Si Heterojunction Solar Cells

Effective utilization of light by transparent conducting oxide layer to enhance the performance of the silicon heterojunction solar cells

Transparent-Conductive-Oxide-Free Front Contacts for High Efficiency Silicon Heterojunction Solar Cells

Natively textured surface hydrogenated gallium-doped zinc oxide transparent conductive thin films with buffer layers for solar cells

Beyond 25% efficient crystalline silicon heterojunction solar cells with hydrogenated amorphous silicon oxide stacked passivation layers for rear emitter

Development of Ito/Layered A-P Si:H Film Stack for Silicon Heterojunction Solar Cells

Dual‐Function Light‐Trapping: Selective Plating Mask of SiOx/SiNx Stacks for Silicon Heterojunction Solar Cells

Modulation of the TCO/MoO x Front Contact Enables >21% High-Efficiency Dopant-Free Silicon Solar Cells

Silicon solar cells with bifacial metal oxides carrier selective layers

Influence of using amorphous silicon stack as front heterojunction structure on performance of interdigitated back contact-heterojunction solar cell (IBC-HJ)