Abstract:Ideal cavities face a high risk of erosion in relation to pneumatic conveying. To reduce erosion, we introduce a height difference in the cavity, with the leading wall higher than the aft wall. To improve the cavity structure, the URANS (SST)-DPM method is adopted to study the effect of height difference h on gas flow, particle distribution, and particle erosion of a horizontal ideal cavity. The simulation procedure is validated by comparing the computational fluid dynamics results with experimental results. The results of the gas flow modeling show that the shear layer impinges on the aft wall when h is relatively small, and re-attaches on the downstream bottom wall as h increases. The re-attachment length is initially identical to the cavity width, then increases uniformly with h. Results of the particle distribution simulations indicate that for a Stokes number (St) of 0.12, the particles are evenly distributed in the cavity, and the distribution is independent of h; for St=1.2, dominated by the centrifugal force, the particles are mainly concentrated along the periphery of the main vortex when h is small. Owing to the variation of the main vortex, as h increases, more particles will fall down into the main vortex. For St=9.1, where gravity is dominant, the particles collide on the aft wall and rebound into the cavity through the main vortex when h is small. Otherwise, particles will move forward and only a few particles appear in the cavity. We explored the erosion distribution on the downstream bottom walls and extracted and analyzed the initial erosion positions. We also investigate the erosion on the aft walls, and the results indicate that lowering the aft wall even slightly will significantly reduce erosion.

Effect of Placements (horizontal with Vertical) on Gas-Solid Flow and Particle Impact Erosion in Gate Valve

Three-dimensional numerical investigation of solid particle erosion in gate valves

Visualization and Influence Factors of Erosion at the Working Edge of a Hydraulic Servo Spool Valve

Numerical investigation and rapid prediction of the erosion rate of gate valve in gas-solid flow

Numerical simulation research for the effect of particle shape on the erosion wear in elbow

Numerical Study of Solid Particle Erosion in a Cavity with Different Wall Heights

Numerical Simulation of the Gas-Solid Flow Around the Valve of Pneumatic Conveying System

The Influence of Governing Valve Opening on the Erosion Characteristics of Solid Particle in Steam Turbine

Solid-liquid Flow Characteristics and Sticking-Force Analysis of Valve-Core Fitting Clearance

Numerical Simulation on Erosion of Pneumatic Drain Valve and optimization on structure

Numerical Simulation on Erosion of Drain Valve

An Experimental Study on Velocity Distribution of Gas-liquid Stratified Flow in Horizontal Steam Injection Well

Numerical study on the flow characteristics of ultrahigh pressure gas affected by valve opening time based a real gas model

Experimental and Theoretical Study of Interface Characteristics of Gas–Liquid Stratified Flow in Horizontal Pipe at High Pressure

Experimental Study on Near Wall Transport Characteristics of Slug Flow in a Vertical Pipe

Flow Patterns and Effects of Liquid Viscosity on the Flow Pattern Transitions in Vertical Downward Pipeline

Experimental Study on the Influence of the Riser on the Gas-Liquid Flow in the Horizontal Pipeline of the Offshore Pipeline-Riser System

Experimental Study on Gas-Liquid Two-Phase Stratified Flow at High Pressure in a Horizontal Pipe

Erosion behavior and influence of solid particles in hydraulic spool valve without notches

3D gas-liquid interfaces and flow characteristics of two-phase flows in horizontal tubes

Experimental Study on Flow Patterns and Transition Criteria for Vertical Swirling Gas-Liquid Flow