Abstract:One of the most important limitations of the atomic force microscopy (AFM) is scanning speed, whose high values are required for contemporary high-resolution, long-range diagnostic applications. The measurement bandwidth of an AFM depends on several factors, but usually results from the time constant of the oscillating cantilever, which is correlated with its resonance frequency and quality factor. We propose a method to overcome this problem by performing the surface measurements when the cantilever is vibrating in higher eigenmodes. In this paper we demonstrate the application of active piezoresistive cantilevers operating in this mode. The active piezoresistive cantilever comprises a piezoresistive deflection sensor, a deflection actuator and a nanotip. It is a complete micro-electro-mechanical system (MEMS), ensuring the highest reliability of cantilever vibration control and detection. Higher eigenmode operations are usually difficult to implement as they usually result in lower deflection and lower sensitivity of the probe vibration deflection. Here we present an experimental modification of the structure of an active piezoresistive cantilever using focused ion beam (FIB) machining that mitigates both weaknesses. This has enabled the cantilever to scan the surface at a scanning rate of 10 lines/s with a maximum speed of 500 μm/s and a data acquisition rate of 10 kS/s, when the probe is vibrating at 380 kHz in the second eigenmode. We also describe a traceable calibration routine (based on analysis of the response of the piezoresistive detector, the output of the HeNe interferometer and precise control of the deflection actuator), together with the cantilever modification process and the development of the measurement setup. We show measurement results of dedicated calibration samples and silicon carbide crystal lattice references.

Piezoelectric Bimorph-Based Scanner In The Tip-Scan Mode For High Speed Atomic Force Microscope

Large-angle and ultra-cold scanner

Towards High Accuracy Surface Profile Characterization in Atomic Force Microscopy

A new type of atomic force microscope with multi-scanners

Wide-Range Scanner With Hinge Mechanism And Its Application In Atomic Force Microscope

Multi Scan Mode Atomic Force Microscope with Improved Properties and High Applicability

A Novel Atomic Force Microscope with High Stability and Scan Speed

A Stitching Method for AFM Based Large Scale Scanning with High Resolution

Atomic Force Microscope in Liquid with A Specially Designed Probe for Practical Application

Application of active piezoresistive cantilevers in high-eigenmode surface imaging

A compact CCD-monitored atomic force microscope with optical vision and improved performances.

Improvement and Application of Scanning Near Field Optical Microscope Based on A Piezoelectric Bimorph Shear Force Beam

Rapid Measurement Of A High Step Microstructure With 90 Degrees Steep Sidewall

Compound Three-dimensional Piezoelectric Scanner Used in Scanning Probe Microscopy

Study of piezo-induced surface vibration in solids using atomic force probe

A novel scanning tunneling microscopy for long range and high aspect ratio measurement

Piezoelectric bimorph-driven ultrasound scanner for high frequency ultrasound imaging

High Speed Piezoresponse Force Microscopy: <1 Frame Per Second Nanoscale Imaging

Active Bimorph-Based Tapping-Mode Distance Control for Scanning Near-Field Optical Microscopy of Biological Samples in Liquid

A Novel Atomic Force Microscope Operating in Liquid for in Situ Investigation of Electrochemical Preparation of Porous Alumina.

A Large-Sample Atomic Force Microscope Observing in Both Air and Liquid