Abstract:A highly sensitive liquid refractive index (RI) sensor with a single-mode fiber-multimode fiber-tapered thin-core fiber-single-mode fiber (SMTTS) structure can be simulated and the method is the beam propagation method (BPM). The modal perturbation between core and cladding mode happened because of modal mismatch and the transmission spectrum is calculated by BPM. Liquid RI and spectral dip wavelength shift for demodulating RI values is obtained and their relationship is approximately linear. To make a comparison, transmissions of single mode fiber-thin-core fiber-single mode fiber (STS) as well as single mode fiber-multimode fiber-thin-core fiber-single mode fiber (SMTS) are also calculated. It is significantly shown that the interference is improved by the segment of multimode fiber (MMF). And the tapered thin-core fiber (TCF) has the functions not only further enhance the fringe visibility, but also increase the RI sensitivity, which is higher with the thinner thin-core taper diameter. The average RI sensitivity would reach up to −116.7nm/RIU within the RI range of 1.33 to 1.39 if the taper diameter is $53.5\ \mu\mathrm{m}$ . This is much higher than the value of SMTS structure. And in the practice application, it could be a slimmer taper in the SMTTS structure to improve the sensitivity just achieving by a simple fabrication process. All process could be finished using fusion splicer, cutter and hydrogen flame.

In-line Microfluidic Refractometer Based on C-shaped Fiber Assisted Photonic Crystal Fiber Sagnac Interferometer

In-Line Photonic Crystal Fiber Optofluidic Refractometer

In-line microfluidic integration of photonic crystal fibres as a highly sensitive refractometer.

Tunable Mode Coupler in the Microfluidic Channel for the Fiber Optics Refractive Index Sensor

Refractive index measurement using photonic crystal fiber-based Fabry-Perot interferometer.

Low-temperature Sensitivity Periodically Tapered Photonic Crystal-Fiber-based Refractometer.

Four-wave Mixing-Based Photonic Crystal Fiber Microfluid Sensor with Embedded U-shape Microslits

High-sensitivity refractive index sensors based on fused tapered photonic crystal fiber

A High Sensitivity Refractive Index Sensor Based on Photonic Crystal Fibre Mach–Zehnder Interferometer

Open Cavity Fabry-Pérot Interferometric Refractometer Based on C-shaped Fiber

An In-Line Optical Fiber Refractometer with Porous Thin Film Coating

Ultra-Sensitive Refractive Index Sensor with Slightly Tapered Photonic Crystal Fiber

Ultrashort and High-Sensitivity Refractive Index Sensor Based on Dual-Core Photonic Crystal Fiber

Microfluidic Refractive Index Sensor Based on an All-Silica In-Line Fabry-Perot Interferometer Fabricated with Microstructured Fibers.

Fast Response Fabry-Perot Interferometer Microfluidic Refractive Index Fiber Sensor Based on Concave-Core Photonic Crystal Fiber.

Theoretical Analysis of an In-line Thin-core Fiber Based Refractometer

All-Fiber Mach-Zehnder Interferometer Using A Tapered Photonic Crystal Fiber for Refractive Index Measurement

Highly Sensitive Intensity-Interrogated Gas Refractometer Using Slotted Photonic Crystal Fiber

Refractive Index Sensing Based on Photonic Crystal Fiber Interferometer Structure with Up-Tapered Joints

A Novel Photonic Crystal Fiber Mach–Zehnder Interferometer for Enhancing Refractive Index Measurement Sensitivity

Simulation of an In-Line Optofluidic Refractive Index Sensor Based on a Seven-Liquid-Core Teflon-Cladding Fiber