Abstract:A novel microfluidic picoliter-scale sample introduction approach was developed by combining the spontaneous injection approach with a capillary electrophoresis (CE) system based on a short capillary and slotted-vial array. A droplet splitting phenomenon at the capillary inlet end during the spontaneous sample introduction process was observed for the first time. On the basis of this phenomenon, a translational spontaneous injection approach was established to reduce sample injection volumes to the sub-100 pL range. A versatile high-speed capillary electrophoresis (HSCE) system was built on the basis of this sample injection approach with separation performance comparable to or even better than those reported in microfluidic chip-based CE systems. The HSCE system was composed of a short fused-silica capillary and an automated sample introduction system with slotted sample and buffer reservoirs and a computer-programmed translational stage. The translational spontaneous sample injection was performed by linearly moving the stage, allowing the capillary inlet first to enter the sample solution and then removing it. A droplet was left at the tip end and spontaneously drawn into the capillary by surface tension effect to achieve sample injection. The stage was continuously moved to allow the capillary inlet to be immersed into the buffer solution, and CE separation was performed by applying a high voltage between the buffer and waste reservoirs. With the use of the novel system, high-speed and efficient capillary zone electrophoresis (CZE) separation of a mixture of five fluorescein isothiocyanate (FITC) labeled amino acids was achieved within 5.4 s in a short capillary with a separation length of 15 mm, reaching separation efficiencies up to 0.40 microm plate height. Outstanding peak height precisions ranging from 1.2% to 3.7% RSD were achieved in 51 consecutive separations. By extension of the separation length to 50 mm, both high-speed and high-resolution CZE separation of eight FITC-labeled amino acids could be obtained in less than 21 s with theoretical plates ranging from 163,000 to 251,000 (corresponding to 0.31-0.20 microm plate heights). The present HSCE system also allowed fast chiral separations of FITC-labeled amino acids under micellar electrokinetic chromatography (MEKC) mode within 6.5 s.

Integration of Pillar Array Columns into a Gradient Elution System for Pressure-Driven Liquid Chromatography

Expression of soluble adenylyl cyclase in lentigo maligna: use of immunohistochemistry with anti-soluble adenylyl cyclase antibody (R21) in diagnosis of lentigo maligna and assessment of margins.

Ladder fall injuries: patterns and cost of morbidity.

Comprehensive Two‐dimensional Separations Based on Capillary High‐performance Liquid Chromatography and Microchip Electrophoresis

Preparation and Application of Chiral Monolithic Column for Capillary Liquid Chromatography

Gradient-Elution Nanoflow Liquid Chromatography without a Binary Pump: Smoothed Step Gradients Enable Reproducible, Sensitive, and Low-Cost Separations for Single-Cell Proteomics

A Pressure-Driven Capillary Electrophoretic System with Injection Valve Sampling.

Pillar Array Mixer for Postcolumn Derivatization Integrated into Liquid Chromatography-Based Microfluidic Device

Valveless gated injection for microfluidic chip-based liquid chromatography system with polymer monolithic column.

Gradient elution in microchannel electrochromatography

Compact Ultrahigh-Pressure Nanoflow Capillary Liquid Chromatograph.

A gravity driven micro flow injection wetting film extraction system on a polycarbonate chip.

Microfabrication of Integrated Capillary Electrophoresis Chips and On-chip Sample Injection and Separation

A High-Throughput Continuous Sample Introduction Interface for Microfluidic Chip-Based Capillary Electrophoresis Systems.

Novel Pinhole Emitter Chip for Micro Supercritical Fluid Chromatography-Mass Spectrometry with Integrated Dilution-Free Fluidic Back-Pressure Regulation

Microfluidic Picoliter-Scale Translational Spontaneous Sample Introduction for High-Speed Capillary Electrophoresis

Sequential injection sample introduction microfluidic-chip based capillary electrophoresis system

Optimization Of The Interface For Coupling Capillary High Performance Liquid Chromatography With Capillary Electrophoresis In Comprehensive Two-Dimensional System

Negative Pressure Pinched Sample Injection for Microchip-Based Electrophoresis.

Microfluidic droplet-array liquid-liquid chromatography based on droplet trapping technique.

Pillar array columns for peptide separations in nanoscale reversed-phase chromatography