Abstract:As society becomes smarter, advanced optical sensing and imaging technologies utilizing visible and near-infrared regions have become increasingly prevalent. Wire-grid polarizers, which are available for broadband electromagnetic waves, are effective in improving the signal-to-noise ratio of such optical systems and enabling more advanced object detection and analysis. However, to be implemented in everyday products, low-cost manufacturing methods must be developed while maintaining high-performance optical functions. To meet these requirements, we conducted an analysis of the geometry of wire-grid polarizers, and designed and developed a wire-grid polarizer with a nano-triangular wave-shaped structure that can be fabricated using general-purpose manufacturing equipment. Once the mould is prepared, this polarizer can be fabricated via nanoimprinting and metal deposition with a normal angle or electroless plating processes. The polarizer fabricated through electroless Ni plating achieves a transmittance of 40%, which is approximately 1.4 times higher than that achieved in a previous study using electroless Ni plating on a rectangular structure with the same period. In addition, the polarizer fabricated through normal angle Al deposition operates over a wide range of wavelengths from visible light to near-infrared, and achieves a polarization extinction ratio of 24 dB at a wavelength of 550 nm and a high transmittance of 81%. High-performance polarizers can be obtained through normal-angle deposition using general-purpose equipment in contrast to the oblique-angle deposition method employed in the manufacture of conventional rectangular structure-based wire-grid polarizers, thereby contributing to cost reduction and improved manufacturability.

A Pitch Tunable Wire Grid Polarizer

Integrated Structure of Polarization Detection in the Visible Spectrum Based on Double Wire Grids

Reduction of Coating Induced Polarization Aberrations by Controlling the Polarization State Variation

300 mm Large Area Wire Grid Polarizers with 50 nm Half-Pitch by ArF Immersion Lithography

Fabrication and Characterization of Bilayer Metal Wire-Grid Polarizer Using Nanoimprint Lithography on Flexible Plastic Substrate

Printing Sub-Thz Wire Grid Polarizers Using A Composite Liquid Metal Ink

Wideband Infrared Metal Wire Grating Polarizer Using Holographic Lithography and Lift-off Process

Wire-grid polarizer sheet in the terahertz region fabricated by nanoimprint technology

Development and analysis of a nano-triangular wave-shaped polarizer

Polarization-Insensitive Flexible-Grid Wavelength-Selective Switch Based on Tapered Couplers and Microring Resonators

The Design of the Sub-Wavelength Wire-Grid Polarizer

Broadband Vis–NIR Circular Polarizer with Cascaded Aluminum Wire‐Grid

Deep-ultraviolet to mid-infrared polarizers by Al nanowire metamaterials

Design of extreme ultraviolet wire grid polarizers by vacuum guiding

Optimization of Bi‐layered Nano‐wire Grids As High‐efficiency Polarizers for Power Recycling in Liquid‐crystal Displays

Large-area flexible infrared nanowire grid polarizer fabricated using nanoimprint lithography.

Large‐Area Wire Grid Polarizer with High Transverse Magnetic Wave Transmittance and Extinction Ratio for Infrared Imaging System

High-performance Subwavelength Polarizer Using "sandwich" Structured Substrates

The Design of the Subwavelength Wire-Grid Polarizers Based on Rigorous Couple-Wave Theory

Fabrication and characterization of high extinction ratio transmission polarizers

Design and Fabrication of Sub-Wavelength Metal Wire-Grid and Its Application to Experimental Study of Polarimetric Imaging