Abstract:The composite crossarm insulator differs greatly from the suspension insulator in structure and arrangement. This study aims to determine the pollution flashover characteristics of composite crossarm insulators under different voltage grades. Four types of AC composite crossarm insulators with diameters ranging from 100 mm to 450 mm are subjected to artificial pollution test, and then the effects of the surface hydrophobicity state of silicone rubber, core diameter, umbrella structure, arrangement, and insulation distance on the pollution flashover voltage of the composite crossarm insulators are analyzed. Under the pollution grade 0.2/1.0 mg/cm2 and voltage grade from 66 kV to 1000 kV, if the silicone rubber surface changes from HC5 to HC6, the pollution flashover voltage of the composite crossarm insulator will increase by 13.5% to 21.0% compared with the hydrophilic surface. If the core diameter changes from 100 mm to 300 mm, the pollution flashover voltage gradient decreases with the increase in core diameter; if the core diameter changes from 300 mm to 450 mm, the pollution flashover voltage gradient increases with core diameter. Under the same insulation height and core diameter, the umbrella structure will have a certain impact on pollution flashover voltage by up to 1.7% to 5.4%. Under the horizontal arrangement, the pollution flashover voltage can increase by 10.5% to 12.1% compared with that under the vertical arrangement. Under the hydrophilic surface and weak hydrophobicity state, the pollution flashover voltage has a linear relationship with the insulation distance. The above results can provide a reference for the structural design and optimization of the composite crossarm insulator.

Research on the Material and Pollution-Flashover Properties of Hard Composite Insulators

Study of DC Arc Characteristics on Polluted Silicon Rubber Surface

Evaluation of Electrical Insulation Properties on Aged Composite Insulators in Heavily Contaminated Areas

Investigation on Hydrophobicity and Pollution Status of Composite Insulators in Contaminated Areas

Influence Factors of Hydrophobicity and DC Flashover Performance for Composite Insulators

Development of Composite Insulators in China

Analysis on Effect of Hydrophobicity on Anti-pollution Flashover Performance of Line Insulators

Non-destructive Condition Assessment of Silicone Rubber Composite Insulators

Flashover Performance of Pre-contaminated and Ice-covered Composite Insulators to be Used in 1000 kV UHV AC Transmission Lines

DC Pollution Resistance Performance of Composite Insulators in High Altitude

Application and Key Technical Study of Composite Insulators

Influence of Environmental Factors on Hydrophobicity Transfer Property of Silicone Rubber Material

Experimental Study on the Pollution Flashover Mechanism of Polymer Insulators

Investigation on Composite Insulators in Contaminated Areas

Study on methods of preventing pollution flashover and wet flashover for 750 kV lines in high altitude area

Flashover Mechanism of Silicone Rubber Composite Insulators

Pollution Flashover Characteristics of Composite Crossarm Insulator with a Large Diameter

Performance of Insulators Treated with Semiconductive Silicone Rubber Coating During Fog and Polluted Conditions

Development of ±660kv DC Composite Insulators

DC pollution flashover and rain flashover performance for composite post insulators at high altitudes

Flashover Characteristic of Polluted Silicone Rubber with Different Hydrophobicity