Abstract:The breakdown and recovery characteristics of the highly repetitive (≤100 kHz) and short nanosecond (∼10 ns) pulsed discharge were investigated. It was found that if one pulse of 40 kV is applied, the air gap between two conical electrodes for a reliable breakdown is only 1 mm; however, if 1000 same pulses are repetitively applied, the longest gap that can be broken down dramatically increases with the increase in the repetitive rate and it reaches 90 mm at 100 kHz. During the preceding pulses that do not cause the breakdown of the gap, long streamers develop from both conical electrodes and nearly bridge the gap, which provides the residual and decaying plasma channels for the rapid breakdown of 90-mm gap in the following pulses, which was experimentally proved to be unique in the extremely non-uniform electric field. The voltage recovery was determined with the two-pulse method and found that the physical processes of the voltage recovery after the short nanosecond pulsed breakdown are similar to that after the microsecond pulsed breakdown, but the time needed for a full recovery in the gas density, in between 50 and 100 μs, is shorter by three orders than that after the microsecond pulsed breakdown. The faster recovery in the gas density may be understood from the small energy of 36 mJ in one nanosecond pulse, which does not induce a high perturbation in the gas density. The evolution in the discharge mode in a 15-mm gap, from corona to diffuse and finally to multichannel spark, with the applied voltage and the repetitive rate was observed. The formation of the multichannel spark is due to the limited energy per pulse that is not enough to heat the primary channel to high conductivity for the collapse of the gap voltage.

Breakdown Characteristics of PCB Paralleled Traces Injected by Rectangular Pulse

Breakdown on Interconnect System of Printed Circuit Board under Square Wave Pulse

Investigation on conductive electromagnetic pulse (EMP) effects on the breakdown of GaAs MESFET-built power amplifiers (PA)

Breakdown Predictions of Microstrip Interconnects and Coplanar Waveguide-Built Devices in the Presence of HP-EMPs

Breakdown characteristics in pulsed-driven dielectric barrier discharges: influence of the pre-breakdown phase due to volume memory effects

Effect of Different Coating Materials on Partial Discharge Characteristics and Electrical Tree of Printed Circuit Board

Power integrity with voltage ripple spectrum decomposition for physics-based design

The Effect of Initial Electrons Generation Approaches on Nanosecond Pulsed Breakdown Characteristics.

A Double-Break Current Injection Vacuum DCCB: Principle and Analysis

Partial Discharge Characteristics on Pressboard Surface under Different DC Polarities

Breakdown Characteristics of Rod-Plate Electrode under Composite AC and DC Voltage

Parallel Breaking Characteristics of Diode-Bridge Power Electronic Switch for DC Circuit Breaker

PD Mechanism Analysis in Oil-Pressboard Insulation with Needle-Plate Defect at Positive DC Voltage Based on Field-Circuit Joint Simulation

Characteristics of electric breakdown in repeated frequency pulse with microcavity effect

Breakdown, Discharge Modes, and Gaseous Recovery of Atmospheric Air with Repetitive 10 Ns Pulses

Investigation On Breakdown Characteristics Between Microscale Gaps Under Nanosecond Pulse

Research on Flashover Characteristics of Typical Interconnect Structures on Printed Circuit Board and Influential Factors under DC Voltage

Pulse breakdown characteristics of microscale gap in micro-electro-mechanical system

Partial Discharge Characteristics in Pre-Breakdown Processes of Oil-Pressboard Insulation with Needle-Plate Defect under AC-DC Combined Voltage

Optical Detection and Characteristics of PCB Partial Discharge in More-electric Aircraft under Square Wave Voltage

Impulse Breakdown Characteristics of Double Vacuum Gaps in Series with Asymmetric Distribution