Abstract:Abstract Here, numerous oxygen-containing functional groups were grafted onto the surface of CNTs to improve their dispersibility in an electrolyte. The CNTs were characterized by FT-IR, Raman, XPS, FE-SEM, and TEM. The results revealed that the dispersibility of the functionalized CNTs in the composites was better than unfunctionalized CNTs. CNTs/Ni composites were deposited on a copper plate by pulsed electrodeposition and ultrasonic dispersion using an electrolytic bath with CNTs concentrations from 0 to 2 g l −1 . The friction and wear behavior of the composite coatings were assessed using two different methods. In the first method, the coatings were scratched with a progressively higher load from 0–100 N, and the results demonstrate a 10 percent reduction in the coefficient of friction (COF) of the composite compared to pure nickel. The other method involved applying a constant load of 30 N, the COF and microscopic wear mechanism were investigated at different carbon nanotube contents, and the results confirmed that the COF of the composites was gradually reduced with the increase of carbon nanotube mass concentration, and the COF was only 0.343 when the carbon nanotube content was increased to 2 g l −1 . According to the XRD results, increasing the CNTs contents changed the preferred growth orientation. Moreover, the FE-SEM images of the wear surface of the 1 g l −1 CNTs/Ni sample indicated that it had the best wear resistance and showed the smoothest wear trace without apparent cracks. The addition of CNTs enhanced the wear resistance of the nickel matrix due to the superior mechanical strength and lubricating effect of the CNTs. CNTs exposed to the matrix surface reduced the direct contact between the Ni matrix and the friction pair, acted as lubricants, and reduced the wear rate.

Fabrication and mechanical property of carbon nanotube/metal composites

Carbon-nanotube-templated Carbon Nanofibers with Improved Mechanical Performance

SYNTHESIS AND THE PERFORMANCE OF CARBON NANOTUBES-(Ni-P) COMPOSITES

Microstructure and Mechanical Properties of ABOw and Nickel-Coated MWCNTs Reinforced 2024al Hybrid Composite Fabricated by Squeeze Casting

Influence on (Ni-P) Electroless Composite Plating with Carbon Nanotubes

Preparation and Tribological Properties of the Carbon Nanotubes–ni–p Composite Coating

Investigation of the microstructure and tribological properties of CNTs/Ni composites prepared by electrodeposition

Fabrication and properties of aligned multiwalled carbon nanotube-reinforced epoxy composites

Fabrication and characterization of CNT-reinforced Ni-Co composite coatings: microstructural evolutions and corrosion behavior

Fabrication and Tribological Properties of Carbon Nanotubes-Aluminum Composites

Mechanical properties of CNT-reinforced Ni3Al composites: the role of chirality, temperature, and volume fraction

Strengthening Ni-Coated CNT/Mg Composites by Optimizing the CNT Content

Processing and Mechanical Property Characterization of Aligned Carbon Nanotube Carbon Matrix Nanocomposites

Fabrication and tribological properties of carbon nanotubes reinforced Al composites prepared by pressureless infiltration technique

Fabrication and Characterization of Aligned Cnt/C Composites

Atomic insights into the tensile behavior of carbon nanotube with different geometrical characteristics embedded in nickel matrix

Tribological properties of Ni–P-multi-walled carbon nanotubes electroless composite coating

Nanoscale Dispersion of Carbon Nanotubes in a Metal Matrix to Boost Thermal and Electrical Conductivity via Facile Ball Milling Techniques

Mechanical and Conductive Properties of Cu Matrix Composites Reinforced by Oriented Carbon Nanotubes with Different Coatings

Properties of Carbon Nano-tubes/Magnesiuum Matrix Composite by Casting

Preparation of Super-Aligned Carbon Nanotube-Reinforced Nickel-Matrix Laminar Composites with Excellent Mechanical Properties