Abstract:The search continues for alternative nontoxic n-type electron transport layers in optoelectronic thin-film devices. Indium oxysulfide, In 2 (O,S) 3 , represents one promising material for this application, especially when paired with chalcogenide absorber layers. The ternary nature of the composition allows for electrical conductivity and optical bandgap tuning by tailoring the sulfur to oxygen ratio in the oxysulfide alloy. However, thin films of In 2 (O,S) 3 are typically deposited only by chemical bath deposition or plasma-enhanced atomic layer deposition. We report deposition of thin films of In 2 (O,S) 3 in a custom-built thermal reactor using only water vapor and hydrogen sulfide as the coreactants. This advance is enabled by the use of a recently reported, highly reactive indium formamidinate precursor. As shown by x-ray photoelectron spectroscopy, the composition can be tuned from pure In 2 O 3 to pure In 2 S 3 by varying the ratio of cycles employing water or hydrogen sulfide. The oxygen to the sulfur ratio in the film can be controlled by altering the dose sequence, although films typically contain more sulfur than would be expected naively from the percentage of hydrogen sulfide doses in the deposition recipe. Rutherford backscattering spectrometry confirms the composition is sulfur-rich relative to the dosing ratio. Structural characterization indicates films are relatively amorphous in nature. Electrically, these films offer reasonably constant electron mobility at different O:S ratios, with an electron concentration tunable over 4 orders of magnitude. These oxysulfide films possess a higher indirect bandgap than their oxygen-free indium sulfide counterparts, indicating higher transmittance to blue light. These indium oxysulfide films may be suitable candidates for electron transport layers in thin-film solar cells where their wider bandgap might result in higher optical transparency and thus short circuit current density, while the tunability of their conduction band offset with an absorber layer may result in higher open circuit voltage.

Optical and Electrical Properties of Indium Oxide Thin Films As Transparent Electrode to Indium Phosphide

Transparent P-Type Conducting Indium-Doped SnO2 Thin Films Deposited by Spray Pyrolysis

In 2 O 3 透明薄膜晶体管的制备及其电学性能的研究

Fabrication and performance of indium oxide based transparent thin film transistors

P-type Transparent Conducting Indium-Tin Oxide Thin Films Deposited by Spray-pyrolysis

Indium oxide—a transparent, wide-band gap semiconductor for (opto)electronic applications

Structural, Electrical, and Optical Properties of ZnInO Alloy Thin Films

Transparent Conductive Indium Zinc Oxide Films Prepared by Pulsed Plasma Deposition

Simple thermal vapor deposition process for and characterization of n-type indium oxysulfide thin films

Transparent conductive In2O3:Mo thin films prepared by reactive direct current magnetron sputtering at room temperature

Comparative Study on Indium Precursors for Plasma-Enhanced Atomic Layer Deposition of In2O3 and Application to High-Performance Field-Effect Transistors

Transparent conductive oxide thin films of tungsten-doped indium oxide

Transparent electric conductive films for optoelectronic devices

Low-Temperature Growth of Indium Oxide Thin Film by Plasma-Enhanced Atomic Layer Deposition Using Liquid Dimethyl(N-ethoxy-2,2-dimethylpropanamido)indium for High-Mobility Thin Film Transistor Application

Preparation and Properties of Indium Tin Oxide Films Deposited by Reactive Evaporation at Different Deposited Rate

Comparative Study of Indium Oxide Films for High‐Mobility TFTs: ALD, PLD and Solution Process

Tungsten-doped In2O3 Transparent Conductive Films with High Transmittance in Near-Infrared Region

Properties of Transparent Conductive In2o3 : Mo Thin Films Deposited by Channel Spark Ablation

In vitro-in vivo extrapolation: estimation of human serum concentrations of chemicals equivalent to cytotoxic concentrations in vitro.

An in-depth examination of opto-electrical properties of In-Yb2O3 thin films and fabricated Al/In-Yb2O3/p-Si (MIS) hetero junction diodes

Effect of film thickness on the properties of indium tin oxide thin films