Abstract:The search continues for alternative nontoxic n-type electron transport layers in optoelectronic thin-film devices. Indium oxysulfide, In 2 (O,S) 3 , represents one promising material for this application, especially when paired with chalcogenide absorber layers. The ternary nature of the composition allows for electrical conductivity and optical bandgap tuning by tailoring the sulfur to oxygen ratio in the oxysulfide alloy. However, thin films of In 2 (O,S) 3 are typically deposited only by chemical bath deposition or plasma-enhanced atomic layer deposition. We report deposition of thin films of In 2 (O,S) 3 in a custom-built thermal reactor using only water vapor and hydrogen sulfide as the coreactants. This advance is enabled by the use of a recently reported, highly reactive indium formamidinate precursor. As shown by x-ray photoelectron spectroscopy, the composition can be tuned from pure In 2 O 3 to pure In 2 S 3 by varying the ratio of cycles employing water or hydrogen sulfide. The oxygen to the sulfur ratio in the film can be controlled by altering the dose sequence, although films typically contain more sulfur than would be expected naively from the percentage of hydrogen sulfide doses in the deposition recipe. Rutherford backscattering spectrometry confirms the composition is sulfur-rich relative to the dosing ratio. Structural characterization indicates films are relatively amorphous in nature. Electrically, these films offer reasonably constant electron mobility at different O:S ratios, with an electron concentration tunable over 4 orders of magnitude. These oxysulfide films possess a higher indirect bandgap than their oxygen-free indium sulfide counterparts, indicating higher transmittance to blue light. These indium oxysulfide films may be suitable candidates for electron transport layers in thin-film solar cells where their wider bandgap might result in higher optical transparency and thus short circuit current density, while the tunability of their conduction band offset with an absorber layer may result in higher open circuit voltage.

Indium oxide—a transparent, wide-band gap semiconductor for (opto)electronic applications

In 2 O 3 透明薄膜晶体管的制备及其电学性能的研究

Fabrication and performance of indium oxide based transparent thin film transistors

Indium Doping-Assisted Monolayer Ga2O3 Exfoliation for Performance-Enhanced MOSFETs.

Theoretical Study on Optoelectronic properties of Layered In2O3 and Ga2O3

A review of band structure and material properties of transparent conducting and semiconducting oxides: Ga2O3, Al2O3, In2O3, ZnO, SnO2, CdO, NiO, CuO, and Sc2O3

Indium-Tin-Oxide for High-performance Electro-optic Modulation

Theoretical Study on Optoelectronic properties of Layered In2O3and Ga2O3

Enabling visible-light absorption and p-type doping in In2O3 by adding Bi

Indium phosphide nanowires and their applications in optoelectronic devices

Wide Bandgap Oxide Semiconductors: from Materials Physics to Optoelectronic Devices

Si-incorporated amorphous indium oxide thin-film transistors

Recent progress on the electronic structure, defect, and doping properties of Ga2O3

Amorphous Semi-Insulating Al-doped In2O3 Growth by Atomic Layer Deposition for Thin-Film Transistors

Simple thermal vapor deposition process for and characterization of n-type indium oxysulfide thin films

Review of Ga2O3-based optoelectronic devices

Effects of Indium Doping on the Crystallographic, Morphological, Electrical, and Optical Properties of Highly Crystalline ZnO Films

Properties, Synthesis, and Device Applications of 2D Layered InSe

Transparent conductive oxide thin films of tungsten-doped indium oxide

Research progress on two-dimensional indium selenide crystals and optoelectronic devices