Abstract:In the RF area MEMS devices are mainly used as switches that utilize mechanical movement to achieve a short or an open circuit in a RF transmission line. RF MEMS switches have shown great potential for the development of a wide range of low loss, low power and low cost systems. It is widely recognized that the advantages offered by the MEMS switch technology cannot be achieved without an appropriate package that will shield and protect the switch, as well as an interconnect technology that will allow for easy RF and DC signal transition in and out of the package. Low loss, wide bandwidth hermetic packages are therefore essential for practical high performance RF MEMS devices. The interconnection to such packaging techniques presents the largest challenge to RF performance. For an interconnection to function largely independent of frequency, the impedance. of the interconnection must be maintained throughout the bonding interface. Although it is used very common in packaging ICs for its characteristics such as simplicity and low cost, wire bonding can not fulfil the requirement of RF MEMS packaging because of the defection existing in the package [1].In this paper, we present the design, simulation and manufacturing of a package solution with lightweight, small size and short electric path length for a millimeter wave MEMS switch structure. To achieve this goal, we used the ultra thin silicon substrate as a packaging substrate. The via holes for vertical feed-through were fabricated on the thin silicon wafer by wet chemical processing. Then, via holes were filled and micro-bumps were fabricated by electroplating. To make up hermetic sealing, metal bonding was used in the sealing line. The switch before and after packaging were simulated by using Ansoft HFSS respectively, and S-parameters simulated show that the package structure has a small impact on the performance of switch, so that we can package the MEMS devices without loss and interference by using the vertical feed-through. Especially, by using the ultra thin silicon wafer we can realize a device package with low-cost, lightweight and small size. In addition, we can extend a 3-D packaging structure by stacking assembled thin packages.

Integration of RF-MEMS, passives and CMOS-IC on silicon substrate by low temperature wafer to wafer bonding technique

A Wafer Transfer Technology for Integration of RF MEMS and CMOS on Organic Substrate

Integration of RF MEMS and CMOS IC on a Printed Circuit Board for a Compact RF System Application Based on Wafer Transfer

Three-solenoid Windings Transformer Baluns on CMOS-grade Silicon Substrate

Novel Monolithic Integration of RF-MEMS Switch with CMOS-IC on Organic Substrate for Compact RF System

Monolithic Integration of a Wafer-Level Thin-Film Encapsulated mm-Wave RF-MEMS Switch in BEOL of a 130-nm SiGe BiCMOS Technology

Wafer-Level Packaging Method For Rf Mems Applications Using Pre-Patterned Bcb Polymer

RF MEMS Switch Integrated on Printed Circuit Board with Metallic Membrane First Sequence and Transferring

The key technologies in silicon based microwave and RF MEMS device fabrication

BEOL modifications of a 130 nm SiGe BiCMOS technology for monolithic integration of thin-film wafer-level encapsulated D-Band RF-MEMS switches

Development of RF MEMS switch on flexible organic substrate with wafer transfer technology (WTT)

A Novel Wafer Level Package Strategy For Rf Mems

Inter-CMOS process for monolithic integrated MEMS resonator

Fabrication of CMUTs with a Low Temperature Wafer Bonding Technology

A Pre-Shaped Wafer Level Packing Strategy for Rf Mems

Successful transferring of active transistors, rf-passive components and high density interconnect from bulk si to organic substrates

Investigation on Wafer Heterogeneous Bonding Process and Performance of CMOS Integrated Circuit on Silicon Carbide Substrate

Monolithic fabrication of film bulk acoustic resonators above integrated circuit by adhesive-bonding-based film transfer

A Novel Approach for Achieving Bulk Silicon MEMS on CMOS Substrate by Au-Au Bonding

Design And Simulation Of A Package Solution For Millimeter Wave Mems Switch

A CMOS Compatible Process for Monolithic Integration of High-Aspect-ratio Bulk Silicon Microstructures