Abstract:Incorporation of bulk carbon nanotube (CNT) conductors into energy and data systems can require new methods of making a functional interface with low electrical contact resistance and high mechanical strength. Ultrasonic welding has been shown as a viable technique for mechanically and electrically bonding commercial CNT materials (CVD) to copper foil. The mechanical strength across the ultrasonic welds was measured via dynamic mechanical analysis with single lap welds exceeding 350 kPa. The electrical properties of the ultrasonically welded bulk CNT conductors (chemically doped with KAuBr4) to Cu were measured via 4‐point probe and show specific contact resistance between the CNTs and copper as low as 4.3 mΩ cm2. Thus, ultrasonic welding represents a mechanically robust method for making functional contacts between bulk CNTs and metallic interconnects with a low contact resistance. In addition, ultrasonic welding was successfully used to join two CNT ribbons end‐to‐end (breaking strength of single lap welds exceeding 200 kPa) demonstrating that it is also a viable technique for making larger dimension CNT materials from smaller components. Ultrasonic welding is shown as a viable technique for mechanically and electrically bonding bulk CNT materials to copper foil without the need for solder, conductive epoxy, or mechanical crimp connects. Ultrasonic welding is also used to join two CNT ribbons end‐to‐end demonstrating that it is a viable technique for making larger dimension CNT materials from smaller components.

Nanorobotic Spot Welding by Attogram Precision Metal Deposition from Copper-filled Carbon Nanotubes.

Nanojoint Formation Between Ceramic Titanate Nanowires and Spot Melting of Metal Nanowires with Electron Beam

Nano-Welding By Scanning Probe Microscope

Metal-filled Carbon Nanotubes for Nanomechatronics

Optically Controlled Local Nanosoldering of Metal Nanowires

10.1063/1.5084134.2

Metal-filled Carbon Nanotubes for Nanofluidic Systems; 2009 IEEE/RSJ International Conference on Intelligent Robots and Systems (IROS 2009); ; 2009 IEEE/RSJ International Conference on Intelligent Robots and Systems : IROS 2009 ; St. Louis, Missouri, USA, 10 - 15

Deformation of Copper Nanowire under Coupled Tension–Torsion Loading

Optimization of Effective Parameters for Improving Adhesion Strength of Copper Nanowire Surface Fastener

Nanorobotic manipulation of carbon nanotubes inside a transimission electron microscope

Improving Adhesion Strength and Thermal Conductivity of Nanowire Surface Fastener

Metal-filled carbon nanotubes for nanofluidic systems: modes of melting and evaporation

Nano-welding and Nano-Cutting with an Electron Beam

Laser-induced Single Point Nanowelding of Silver Nanowires

Decrease of contact resistance at the interface of carbon nanotube/electrode by nanowelding

Au80Sn20-based Targeted Noncontact Nanosoldering with Low Power Consumption.

Photothermal‐Induced Nanowelding of Metal–Semiconductor Heterojunction in Integrated Nanowire Units

Ultrasonic Welding of Bulk Carbon Nanotube Conductors

Comprehensive Atomistic Modeling of Copper Nanowires-Based Surface Connectors

Engineering Multiwalled Carbon Nanotubes Inside a Transmission Electron Microscope Using Nanorobotic Manipulation

Laser Welding of a Single Tungsten Oxide Nanotip on a Handleable Tungsten Wire: A Demonstration of Laser-Weld Nanoassembly