Abstract:The discovery of an ordered L1 2 precipitate (Co 3 (Al, W)) phase in the ternary Co‐Al‐W system in 2006 which is stable up to temperatures of 950 °C attracts significant research on microstructure design for a new class of load‐bearing Co‐base high‐temperature alloys. The low mismatch between the fcc γ‐Co solid‐solution phase and the L1 2 γ'‐Co 3 (Al, W) phase helps to establish a microstructure with coherent cuboidal γ' precipitates embedded in a continuous γ matrix, analogous to Ni‐base superalloys. These new Co‐base superalloys have the potential to exhibit excellent high‐temperature mechanical properties and are considered to be ideal turbine blade materials. In the ternary Co‐Al‐W system, it is reported that the L1 2 phase is in equilibrium with the B 2 ‐CoAl and D0 19 ‐Co 3 W phases and transforms into those after extended annealing [1] . In order to increase the temperature capability and stabilize the γ'‐L1 2 phase, additional alloying elements are added to the Co‐Al‐W system. With additions of Cr, Mo, Ni, Re, Ta and V, the solidus and liquidus temperatures of Co‐Al‐W alloys are 100‐150 °C higher than those of advanced Ni‐base single‐crystal alloys strengthened by the L1 2 phase [2] . It is speculated in literature that Mo, V, Nb, Ta and Ti increase the γ' solvus temperature of Co‐Al‐W superalloys because they occupy B‐sites in the A 3 B ordered γ' phase and thereby increase its volume fraction, while Fe, Mn and Cr tend to distribute to the γ phase and decrease the amount of γ' phase [3] . Because the distribution of additional elements will influence the morphology and amount of the γ' phase, it is important to investigate their partitioning behavior and atomic site occupation in the Co‐Al‐W system. Therefore the high‐temperature strength and thermal stability of Co‐base superalloys are optimized. In this study, alloy samples with nominal compositions Co‐9Al‐9W‐2X (X=Ti, Nb, V, Ta, Cr and Mo, at.%) were produced. The partitioning behavior of the alloying elements between γ and γ' phases were investigated by energy‐dispersive X‐ray spectroscopy (EDS) in the transmission electron microscope (TEM). In order to analyze the element occupation at atomic sites, atom location by channeling enhanced microanalysis (ALCHEMI) technique was applied. The details about the partitioning behavior and the atomic site occupation of alloying elements will be discussed in the presentation.

Microstructural Evolution of a Newly Developed γ' Strengthened Co-base Superalloy

Microstructure of a newly developed γ′ strengthened Co-base superalloy

Microstructures and Mechanical Properties of a L12-structured Precipitation Strengthened Co-based Superalloy

Microstructure and Tensile Behavior of a Novel Monocrystalline Co‐Based Superalloy at Different Temperatures

Microstructure Evolution of Multicomponent γ ′-Strengthened Co-Based Superalloy at 750 °C and 1000 °C with Different Al and Ti Contents

Microstructures and Mechanical Properties of a L1 2 -structured precipitation Strengthened Co-based Superalloy

Microstructural Evolution and Compression Property of a Novel Γʹ-Strengthened Directionally Solidified CoNi-base Superalloy

Microstructure and Mechanical Properties of a Novel Γ′-Strengthened Multi-Component CoNi-Based Wrought Superalloy

Design of Cuboidal Γ/γ' Coherent Microstructure and Its Stability in Low-Density Co-Ni-Al-Mo-Cr-Ti/Nb/Ta Superalloys

Microstructure evolution of Al rich Co-Al-W base superalloy during heat treatment

Microstructural Characterization of Co-Based ODS Alloys

Microstructure and Properties Evolution of Co-Al-W-Ni-Cr Superalloys by Molybdenum and Niobium Substitutions for Tungsten

Microstructure evolution and its impact on mechanical properties of a cobalt-based superalloy subjected to long-term heat-treatments

A New Co-Base Superalloy Strengthened by Gamma' Phase

Effect of Ti/Nb/Ta addition on the γ/γ' coherent microstructure in low-density and high-strength Co-Al-W-Mo-based superalloys

Microstructural Evolution and Mechanical Properties of a Ni-Based Superalloy, TMW-4

Effect of γ' phase and microtwins on the microstructural evolution and mechanical properties of a novel Ni–Co base superalloy

Microstructure and mechanical properties of a new Ni–Co based superalloy at intermediate temperatures

Element Partitioning and Atom Location of Alloying Elements in Co ‐base Superalloys

High-Temperature Structural Stabilities of Ni-Based Single-Crystal Superalloys Ni–Co–Cr–Mo–W–Al–Ti–Ta with Varying Co Contents

Microstructural stability of low-cost Ni-base superalloys with a high volume fraction of cuboidal á nanoprecipitates